SECTION 2: CIRCUIT REQUIREMENTS
220/440V 3-Phase
Serious personal injury could occur if you connect your machine to the power source before you have completed the set up pro- cess. DO NOT connect the machine to the power source until instructed to do so.
Wiring
The Model G0451 is prewired for 220V
Amperage Draw
The Model G0451 has a 10 HP main motor and a 1 HP scoring blade motor; combined they will draw the following amps:
Motor Draw at 220V | 28 Amps |
Motor Draw at 440V | 14 Amps |
Minimum Circuit Requirements
Only connect your machine to a circuit that meets the requirements below. Check to see if the wires and circuit breaker in your circuit are capable of handling the amperage draw from your machine, as well as any other machines that could be operating on the same circuit. If you are unsure, consult a qualified electrician.
220V Circuit | 30 Amp |
440V Circuit | 15 Amp |
Minimum Cord Requirements
Use the following type of cord to connect your machine to power (a cord is not provided):
Cord | 4 wire |
Gauge | 10 Gauge |
G0451 14" Sliding Table Saw |
|
Connection Type
Because of the high amperage draw from this machine, we recommend that you hardwire it directly to your circuit breaker and install a locking
Figure 6. A power disconnect is preferable to
high current plugs and receptacles.
A fire may occur if your particular electrical configuration does not comply with local and state codes. The best way to ensure compli- ance is to check with your local municipality or a qualified electrician.
