Moffat PFSS6SKXSS Refrigerator Location, Clearances, Plug in the Refrigerator

Page 10

Installation Instructions

INSTALLING THE REFRIGERATOR

REFRIGERATOR LOCATION

•Do not install the refrigerator where the temperature will go below 60°F (16°C) because it will not run often enough to maintain proper temperatures.

•Do not install the refrigerator where the temperature will go above 100°F (37°C) because it will not perform properly.

•Install it on a floor strong enough to support it fully loaded.

CLEARANCES

Allow the following clearances for ease of installation, proper air circulation and plumbing and electrical connections.

 

Standard Depth

 

Models

Sides

1/8″ (3 mm)

Top

1″ (25 mm)

Back

1″ (25 mm)

1PLUG IN THE REFRIGERATOR

On models with an icemaker, before plugging in the refrigerator, make sure the icemaker power switch is set to the O (off) position.

See the grounding information attached to the power cord.

2PUT THE REFRIGERATOR IN PLACE

Move the refrigerator to its final location.

3LEVEL THE REFRIGERATOR

Adjustable legs at the front corners of the refrigerator should be set so the refrigerator is firmly positioned on the floor, and the front is raised just enough that the door closes easily when opened about halfway.

To adjust the leveling legs, turn the legs clockwise to raise the refrigerator, counterclockwise to lower it.

10

4

REMOVE THE FRESH FOOD

DOOR HANDLE

(For placement in the installation location or reversal of the handles – on some models)

Stainless steel (on some models):

AREMOVING

THE DOOR

 

HANDLE: Loosen

 

the set screws

Badge

with the 3/32″

A

Allen wrench

 

and remove

 

the handle.

B

NOTE: For

 

Double Door

Mounting

models follow

Fasteners

the same

(appearance may vary)

procedure on

 

the opposite door.

 

Plastic handle (on some models):

AREMOVING THE DOOR HANDLE: Depress the tab on the underside of the handle and slide the handle up and off of the mounting fasteners.

REVERSING THE

 

DOOR HANDLE

 

(on some

B

models):

 

• Remove

Badge

the handle

 

mounting

A

fasteners with

a 3/16″ Allen

 

wrench and

Mounting

transfer

Fasteners

the handle

 

mounting

(appearance may vary)

fasteners to

 

the right side.

 

•Remove the logo badge.

•Remove and transfer the plug button to the left side of the fresh food door. NOTE: Use a flat plastic edge to prevent damaging the door. Remove any adhesive on the door with a mild detergent. Remove the paper covering on the adhesive backing on

the logo badge prior to carefully attaching the badge to the door.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Controls Safety InstructionsInstallation Instructions Normal Operating SoundsRefrigerator or Freezer Unplug the refrigerator before cleaning and making repairsBefore You Throw Away Your Old Do not refreeze frozen foods which have thawed completelyHOW to Connect Electricity Moffatappliances.caAbout the shelves and bins Non-Adjustable Shelves on the DoorAbout the controls Rearranging the ShelvesAbout the crispers and pans Adjustable Humidity Crisper on some modelsFruit and Vegetable Crisper Freezer Shelves and Baskets Non-Adjustable Shelf on Freezer DoorAbout the freezer compartment Basket RemovalCleaning the Inside Care and cleaning of the refrigeratorCleaning the Outside Behind the RefrigeratorPreparing to Move Replacing the light bulbsPreparing for Vacation Refrigerator LightsRead these instructions completely and carefully Before YOU BeginPreparation Moving the Refrigerator IndoorsPlug in the Refrigerator Refrigerator LocationClearances PUT the Refrigerator in PlaceAttach the Freezer Door Handle Attach the Fresh Food Door HandleRemove the Freezer Door Handle Leveling legs have 2 purposes Set the controls to the recommended settingSET the Controls Refrigerator, counterclockwise to lower itRemove the Refrigerator Door Important NotesTools YOU will Need Set the door on a non-scratching surface with the inside upTransfer Center Hinge Bracket Remove Freezer DoorRemove Bottom Hinge and Leveling LEG Rehang Freezer Door Install Bottom Hinge and Leveling LEGTransfer Refrigerator Door Handle to Right Install the Logo Badge Rehang Refrigerator DoorNormal operating sounds Before you call for service…Problem Possible Causes What To Do CLICKS, PopsConsumer Support Troubleshooting Tips See About the controlsSee Replacing the light bulbs Instructions Ownership Registration Page What is covered How Long Warranted Parts Labour What is not CoveredTerms and Conditions Consumer Support GE Appliances Website Schedule ServiceParts and Accessories Extended WarrantiesChangement du sens Mesures de sécurité . . . . . . . . . .2Ils figurent sur l’étiquette qui se trouve Tous les appareils de réfrigération contiennent RéfrigérantsSe blesser gravement Démontez les portesRaccordement Électrique Electromenagersmoffat.caMise en place des clayettes Les commandes avec réglages de températureLes clayettes et les balconnets Clayettes non-réglables de porteBacs à fruits et légumes Bacs à rangement et bacs à légumeBac à légume à humidité réglable sur certains modèles Enlèvement du panier Compartiment congélationClayettes et paniers du compartiment congélation Enlèvement de la clayette fixeNettoyage de l’intérieur Entretien et nettoyage de votre réfrigérateurNettoyage de l’extérieur Derrière le réfrigérateurDéménagement Remplacement des ampoulesDépart en vacances Lumières du compartiment réfrigérationPréparation Déplacement DU Réfrigérateur À L’INTÉRIEUR DE LA MaisonAvant DE Commencer Outils Dont Vous Pouvez Avoir BesoinDégagements Emplacement DU RéfrigérateurEnlevez LA Poignée DE Porte Enlevez LA Poignée DE LA Porte DU Compartiment Congélation Fixez LA Poignée DE LA PorteDU Compartiment Aliments Frais Fixez LA Poignée DE LA Porte DU Compartiment CongélationLes pieds de nivellement jouent deux rôles Réglez LES CommandesMettez LE Réfrigérateur DE Niveau Enlevez la grille en dévissant les deux vis à tête PhillipsPour changer le sens d’ouverture des portes Outils NécessairesEnlèvement DE LA Porte DU Compartiment Réfrigération Fermez la porte et attachez-la avec le ruban masqueFaites Passer LE Support DE LA Charnière Centrale Faites Passer LE SupportEnlevez LA Charnière Inférieure ET LA Patte DE Nivellement Installez LA Charnière Inférieure ET LA Patte DE Nivellement ’aide d’une clé à douille 5/16 po, installezFixez LE Logo Remise EN Place DE LA Porte DU Compartiment CongélationRE-SUSPENSION DE LA Porte DU Compartiment RéfrigérationProblème Bruits de fonctionnement normauxAvant d’appeler un réparateur… Causes possibles Correctifs Le réfrigérateur’arrête fréquemment Causes possibles Correctifs Le moteur fonctionnePendant de longues Les réfrigérateursProblème Causes possibles Page Ownership Registration Page Termes ET Conditions Exclusions DE LA GarantieSoutien au consommateur Service de réparationsPièces et accessoires Prolongation de garantie

PFSS6SKXSS specifications

The Moffat PFSS6SKXSS is a highly regarded commercial refrigerator designed to meet the rigorous demands of the food service industry. Combining innovative technology with a robust build, this unit is tailored for restaurants, cafes, and catering businesses that require reliable and efficient refrigeration solutions.

One of the standout features of the PFSS6SKXSS is its impressive capacity, providing ample storage for a variety of perishable goods. With multiple shelving options, it allows users to optimize storage space, accommodating both bulk ingredients and smaller items efficiently. The design promotes easy organization, ensuring that products are easily accessible and visible, which is crucial for maintaining workflow in busy kitchens.

In terms of technology, the Moffat PFSS6SKXSS is equipped with advanced refrigeration systems that ensure consistent temperature control. Operating in a range between 0 to 4 degrees Celsius, the unit helps maintain the quality and safety of food items, significantly reducing the risk of spoilage. The electronic controls are user-friendly, providing real-time temperature monitoring and adjustments at the touch of a button, enhancing operational efficiency.

Constructed from high-quality stainless steel, the PFSS6SKXSS is not only durable but also easy to clean, making it ideal for high-traffic environments. The material is resistant to corrosion and wear, ensuring longevity and consistent performance. Additionally, the sleek, modern design fits seamlessly into various kitchen layouts, enhancing the professional appearance of any establishment.

Another notable characteristic is the energy efficiency of this refrigerator. The PFSS6SKXSS is designed with environmentally-friendly refrigerants and energy-efficient components, helping businesses reduce their carbon footprint while also lowering operating costs.

Safety features such as lockable doors and interior lighting add convenience and security, while adjustable feet provide stability on uneven surfaces, making it a versatile addition to any kitchen.

Overall, the Moffat PFSS6SKXSS stands out in the competitive landscape of commercial refrigeration units. Its blend of capacity, advanced temperature control, durability, and energy efficiency makes it a reliable choice for food service operators looking for a dependable refrigeration solution that enhances productivity and food safety.
Top Page Image Contents