Using
1Lift up the lid and fill the kettle. The integrated water level gauge/ viewing lid (on certain models) allows you to easily see the amount of water
in your kettle.
•Always put enough water to cover the bottom of the kettle, minimum 1 cup 200cc.
•Boil only as much water as you need
as this saves electricity.
2Place the kettle on the base unit, ensuring the kettle locates on to the
360o connector.
•The 360o connector allows the kettle to be located at any position - ideal for left and right handed users and convenient positioning on your
worktop.
3Plug in and switch on at the wall socket.
4Switch the kettle on. The ‘power on’ indicator neon will light up.
5When lifting the kettle from the base unit by the handle ensure you hold
the kettle level.
•To reboil, switch to ON again. If the kettle has just switched off wait several seconds or so before switching it back on again.
•If you do not put in enough water, or switch on the kettle when it is empty, the safety
Filter removal
1Open the lid.
2Lift the filter upwards from its location using the tab provided.
3To refit the filter, slot into the side wall guides and press down firmly. Ensure the filter is correctly located into the central guide.
Cool Steel kettle
1Open and support the lid.
2Pull the filter downwards from its location.
3To refit the filter locate the filter into the grooves and click into place.
Note: Which way you have removed the filter and replace the same way after cleaning.
Warning : Unless the filter is fitted correctly, the kettle lid may not close and lock securely.
Cleaning the filter
1To clean the filter run warm water over the mesh and scrub lightly to remove the soft deposits with a suitable brush. A toothbrush would be ideal.
2If the soft lime deposits have become hard, the filter will need descaling, see descaling page 5.
4