Insert the drip tray (3).

 COFFEE READY



16.6 Filling the bean tank

 COFFEE READY

 FILL BEANS

If this information is displayed, the machine will no longer make coffee. The machine will still make hot water and frothed milk, however. Refill beans as described in Chapter 2.4.

 COFFEE READY



Open the cover of the bean tank (7) and remove the aroma preservation cover (8).

Remove any beans with a vacuum cleaner.

Insert the key (Fig. 12).

Now turn the key conter-clockwise until the jammed stone is

 

released.

E

 Remove any remaining powder with a vacuum cleaner.

 Fill up with fresh beans.

 

16.9 Changing the filter

 

 

 

After having used 50 litres of water or after two months, the

 

 

 

 

 

 

 

 

 

filter cartridge will be used up. The display will prompt you

 

 

 

 

 

 

to change the filter.

 

Refer to Chapter 5.2 “Changing the filter”.

 

16.7 Aroma preservation cover missing

 BEANCOVER

 MISSING

If this information is displayed, the machine will no longer make coffee. The machine will still make hot water and frothed milk, however. The aroma preservation cover (8) has not been installed or not been installed properly.

Install the aroma preservation cover (8).

 COFFEE READY



16.8 Removing stones from the grinding gear

Switch the machine off using the ON / OFF key (A).

Turn the power switch (15) off.

16.10 Information about cleaning cycle

After having dispensed 220 products or after 160 rinsing cycles, the IMPRESSA must be cleaned. You will be informed of this by a message on the display. The machine will still make coffee, hot water and frothed milk. However, we recommend that you should run the cleaning cycle (Chapter 17) within the next few days.

 COFFEE READY

 CLEAN

After the machine has dispensed another 30 products, the display begins to flash. You should run the cleaning cycle now (Chapter 17).

 COFFEE READY

 CLEAN (flashing)

31

Page 31
Image 31
Jura Capresso Z5 manual Filling the bean tank, Aroma preservation cover missing, Removing stones from the grinding gear