Cleaning
Cleaning Guidelines
Caution
Always turn off electrical power at the mains supply before commencing cleaning.
This oven is not water proof. Do not use water jet spray to clean interior or exterior of the appliance.
To achieve the best results, cleaning must be regular and thorough. If any small faults occur, have them looked at promptly. Don't wait until they cause a complete breakdown.
NOTE:
•Carefully read and follow the safety instructions on the label of the cleaning product to be used.
•DO NOT use harsh abrasive scouring pads or abrasive detergents as they could damage the oven.
•Ensure that any detergent or cleaning material has been completely removed after each cleaning.
To keep your oven clean and operating at peak efficiency, follow the procedures shown below:-
Oven Cleaning
NOTE:
•If the oven usage is very high, the cleaning procedure should be carried out on a more frequent basis.
•Allow the oven interior to cool to approx 50˚C / 120˚F before commencing cleaning.
Stainless Steel Surfaces
a.Thoroughly clean the exterior surfaces of the oven with a damp cloth moistened with a mild detergent solution or a soft bristled brush.
b.Baked on deposits or discolouration may require a good quality stainless steel cleaner. Always apply cleaner when the oven is cold and rub in the direction of the grain.
Side Racks
a.Remove the wire oven racks.
b.Partially undo the rack / baffle securing screw (anti- clockwise) securing the rack to oven wall, until the rack is loose.
Fan Baffle
Securing Screw
Add Image of location of Rack Thumbscrew with rack in place.
c.Pull racks forward to disengage the location pins at the rear of rack from the fan baffle, remove the side racks from the oven.
Side Rack
Rear
Location
Pins
d.Clean all racks with a mild anti bacterial detergent and hot water, using a soft bristled brush.
e.Dry the racks thoroughly with a dry cloth.
f.To refit the racks, engage the locating pins at the rear of side rack into the locating holes in the fan baffle at the rear of the oven.
g.At the same time locate the front of the rack over the rack / baffle securing screw and hand tighten the rack / baffle securing screw.
h.Refit the wire oven racks to the oven.
Fan Baffle (Not E22M3)
a.Remove side racks as shown previously.
b.Undo
Securing Screw
Location
Brackets 
c.Tilt the fan baffle forward and lift up off the location brackets at rear of oven.
d.Clean the fan baffle with mild anti bacterial detergent and a hot water solution using a soft bristled brush.
e.Dry fan baffle thoroughly with a soft dry cloth before
f.Refit the fan baffle and hand tighten the rack / baffle securing screw(s) to secure the fan baffle.
7