Figure | 7 |
|
|
If the blade assembly | is too tight to turn by ha | ||
the locking ring may be used to loosen the blad | |||
assembly as shown in | figure 7d After loosening | ||
turn the blade assembly counterclockwise until it | |||
stops and then | lift up | The gasket may be remo | |
for | cleaning as | shown | in figure 7f |
Wash the blade/base assembly under running wa/ ter Do not place the blade/base assembly in the dishwasher or allow it to stand in water This w tend to wash out the lubricant After cleaning rin thoroughly and dry before using
2.To assemble or reassemble blade/base assembly into the blender reverse the steps that were use in.the.above to remove it
3.The blender is used in mode 3 see table 1 Toplace the blender on the power unit the arm must be rotated to the down position Depress t release button see 4a and lower the arm so th the arm is vertical and the high/speed drive is straight up If you have not already done so re move the motor drive cover from the high/speed drive and place the blender on the high/speed d and turn counterclockwise to lock the blender in place
22