stream, as shown in figure 8b. Operate the blender speeds 1 or 4 until mixture is thick and smooth (approximately
Tips | The | blender | should | be operated with | careful | conside | ||
| ation | as to | what | is | required and/or | desired. | The sp | |
| at which the blender is operated and the length of | |||||||
| operation for a given job will depend upon | the deg | ||||||
| of fineness desired or the amount being blended. | |||||||
| When the blender | is being | used on | dry materials, s | ||||
| as nuts or | bread, | the best | results will be obtained | ||||
| when | the blender | jar is filled with approximately ½ | |||||
| of material | to be | blended. If the blender does not | |||||
| (even after trying the highest speed), the blade has | |||||||
| become blocked by | the contents. |
|
|
The power unit should be:
1.Switched to off, •O/Off" and unplugged.
2. The mixture should be | removed and the contents |
at the bottom of the | jar loosened. |
Removing Contents Before beginning to remove the contents from the blender, make sure that the power unit has been turned to off position •O/Off." Remove the blender from the power unit by turning the blender clockwis while lifting. With the blender removed from the pow unit, the contents of the blender may now be pour into a<suitable container or bowl, as desired. Replace the cover on the high=speed drive.
Care and Cleaning All components of the blender, except the blade/bas
ofBlender assembly, are dishwasher safe. It is recommended that the blade/base assembly be cleaned only under
flowing water rather than in the dishwasher. Soap a detergent will tend to<wash out the bearing lubricant the blade/base assembly. Do not use scouring clean ers on any of the blender parts.
The power unit of the kitchen machine should be cleaned with a clean, damp cloth only. Never use coarse or caustic cleaning products to clean this ap pliance. Never immerse the power unit in water. Ne use a steam cleaner.
24