APW Wyott FT 800H operating instructions General Information, Installation Instructions

Page 4

!

CAUTION: The National Sanitation Foundation (NSF) requires that units over 36” (91 cm) in length

or weighing more than 80 lbs. (36 kg) to be either sealed or raised on the installation surface. If this

unit cannot be sealed at the point of use, 4” (10 cm) legs are included to allow for proper cleaning !

 

access below unit.

WARNING: Genuine APW Wyott Replacement Parts are specified to operate safely in the environments in which they are used. Some aftermarket or generic replacement parts do not have

!

the characteristics that will allow them to operate safely in APW Wyott equipment. It is essential to

!

use APW Wyott Replacement Parts when repairing APW Wyott equipment. Failure to use APW

Wyott Replacement Parts may subject operators of the equipment to hazardous electrical voltage, resulting in electrical shock or burn.

CAUTION: Locate the unit at the proper counter height, in an area that is convenient for use. The

! location should be level to prevent the unit or it’s contents from accidentally falling, and strong ! enough to support the weight of the unit and food.

!

WARNING: Failure to provide clearances will cause unit failure and invalidate warranty claims

!

(see installation instructions).

GENERAL INFORMATION

I.Consult the rating label for model and serial number. Write this information below before proceeding:

A. Model # __________________

B. Serial # __________________

II.Overall Dimensions w/Wire Feeder - 16.1" H (409mm) x 15.2" W (385 mm) x 22.8"D (579mm)

III.Product Opening - 3.0" H (76mm) x 10.50" W (267mm)

IV.

Productivity (per hour) - results will vary depending on line voltage and bread dryness.

V.Electrical Requirements

A.Single phase, 208-240 volts, 2850 watts, 13.7 amps.

B.Cordset configuration

1.Each toaster is equipped with a three-wire grounded cordset and standard three-prong plug.

2.In the United States, a four foot cordset with NEMA 6-20P plug.

3.In Canada, a six foot cordset with NEMA 6-20P plug.

Net/Shipping Weight - 44Ib.(20.0kg) /52Ib.(23.4kg)

INSTALLATION INSTRUCTIONS

I.Check Contents - refer to Figure 1, account for the following parts:

A.Toast Drawer - shipped in place

B.Reflector Tray - shipped in place

C.Wire Feeder - inside Reflector Tray

D.Instruction Manual - shipped loose

NOTE: DO NOT OPERATE THE TOASTER WITH THE REFLECTOR TRAY REMOVED FROM ITS POSITION

II.Position Wire Feeder - refer to Figure 2

A.Pull out Reflector Tray

B.Rotate Wire Feeder

C.Slide Reflector Tray back

D.WARNING: Operating the toaster without the Reflector Tray reduces toasting capabilities.

figure 2

4

Image 4
Contents Installation Operating Instructions Table of ContentsSafety Precautions Important for Future ReferenceImportant Safety Instructions With EN 60335-1 and/or local codesInstallation Instructions General InformationCleaning Instructions Operation InstructionsWarranty Procedure TroubleshootingProblem Cause Solution Replacement Parts List FT 800H Item P/N DescriptionExploded View FT 800H Wiring Diagram Model FT 800H APW Wyott Equipment Limited Warranty Phone 214 Fax