APW Wyott M95-2-JIB operating instructions Troubleshooting Guide, Also needed, Re-Assembly

Also needed:

(Wet) terry towel

Catch pan for food soil (Butter Pan can be used) Common kitchen scraper

If Teflon sheet is installed remove it when Bun Grill Toaster is cool.
Step 1.	Set the toaster temperature to 350°F.
Step 2.	Scrape loose food particles with scraper into Butter Pan under grill plate.
Step 3. Squeeze 1 to 2 ounces of Scotch-BriteTMQuick Clean Small Appliance Cleaner No. 702 or
	equivalent into measuring reservoir of bottle. Pour cleaner onto pad. Do not pour directly
	onto grill surface.
Step 4. Scour using Scotch-BriteTMMulti-Purpose Pad Holder No. 405 or equivalent, and Scotch-
	BriteTMGriddle Polishing Pad No. 46 (or 9650). (See Figure 3)
Step 5.	After scouring, squeegeeTM	the surface clean with the Scotch-BriteTMSqueegee No. 410 (See
	Figure 5)
Step 6. Turn off Bun Grill Toaster and wipe surface with clean wet towel. If the surface is still hot, use
	the Scotch-Brite Multi-Purpose Pad Holder to move the towel over the surface. (See

Figure 5)

Step 7. Dry the grill thoroughly. Season the grill plate by applying a light coating of cooking oil o the

grill plate. Allow		e griddle to heat up for 20 minu es. After 20 minutes season the grill
surface again by		pplying another coating of oil to the ent re grill surface.
Step 8. Rinse all cleaning tools with hot water. (See Figure 6)
Step 9. Wipe down all ex ernal stainl ss steel surfac s ith a damp cloth.
FIGUREScourgrill.3	CleanwithsqueegeeFIGUREgrillsurface4		WipecleanFIGUREthegrillwettowelwith5 .	RinseFIGUREtoolswithwater6 .

RE-ASSEMBLY

Before assembling the conveyor check the following: Fasteners on the Conveyor Assembly hardware should be tight with no signs of wear8. Conveyor shaft gear and the Motor Shaft gear are tight. Hanger Bracket screws are tight and the brackets have not shifted during use.

8. TROUBLESHOOTING GUIDE

Always ask and check the following:

1. Is the unit connected to a live power source of the proper voltage?

2. Check the circuit breaker.

3. Is power switch “ON” and pilot light glowing?

4. Check the rating label. Is the unit connected to the correct power source?

If the above checks out, and you still have problems, call an APW Wyott authorized service agent. APW SERVICE HOT LINE: 1-800-733-2203.