Maytag 860S manual Problems Possible causes Action, Water remains, Machine

Page 28

Problems

Possible causes

Action

pump) can be heard from the machine, this does not stop when the power is switched off using the main power switch.

2.Pull out the plug.

3.Call a service engineer

Water remains in the

• Obstruction in the drain

machine.

hose.

Disconnect the drain hose where it is connected to the sink’s water trap. Check that no debris has become stuck. Is the cone-shaped part of the pipe cut so that the diameter is at least 16 mm?

Bad odour in the machine

The dishes are not sufficiently dry

Kinks in the drain hose.

The filters are clogged.

Items in the drain pump.

Dirt along the strips and in corners

Drying power too low. The machine is not fully loaded.

The rinse aid has run out or the set dose is too low.

Check that the hose is free from kinks or sharp bends.

Clean out the coarse filter, the fine filter and the filter.

Clean out the drain pump. See chapter on cleaning

Clean with a dish brush and low-lather detergent.

Activate the Normal drying option (not all models).

Put a full load in the machine.

Replenish rinse aid or increase the dose of rinse aid.

Open the door slightly once the program has finished.

28

Image 28
Contents Maytag MSE 860 Fars Quick Guide Loading basketsDispensing dishwasher detergent Close the door Mini Program GuideContents Salt Setting water hardness Rinse aidSearch words Performance informationBefore doing your first wash Safety Child Safety AdviceChild-safe button lock Child-safe dishwashingParts of the dishwasher Technical informationBaskets Control panel DispenserBasic Course Load the baskets correctlyPress the main switch and select programme Temperature OptionsSelect options DryingEco-dishwashing Specialsettings If the machine is switched off with the main switch Press Start/Stop and close the doorChanging options Do you want to load more dishes?Fragile dishes Standard program Tested program55˚C 50˚C 30˚C Display Cleaning Coarse filterFine filter Drainage pumpDoor Spray armsTip Machines with refill indicator Rinse aidPour in rinse aid Select dosageSalt Indicator is not workingApplies to dishwashers with water softeners Pour in salt Fault indications Display Type of fault ActionTroubleshooting ProblemsDishes are not clean Stains or a film on the china Possible causesProblems Problems Possible causes Action Water remainsMachine Bad odour in the machine Dishes are not sufficiently dryPerformance information Test dosageEnergy labelling Example of dishwasher loadingInstallation Suggestions on positioning the dishwasherTechnical data Connection to waterConnection to electricity Connection to drainageAdjusting machines with six feet freestanding dishwasher Adjusting machines with three or four feetAdjusting machines with adjustable foot Positioning the machineFitting fixed kick-plate Fitting strip seal Adjusting the plinthScrew the dishwasher into place Setting water hardness Setting water hardness machines with water softenerService Service & guaranteeGuarantee Own comments Own comments Own comments Search words