Connection to water
There must be a
The water supply pipe has a connection with a 1/2” or 3/4” internal thread depending on country.
When the installation is complete, the shut- off tap should be opened to allow the pres- sure to settle for a while and to check that all connections are tight.
Connection to electricity
A dishwasher fitted with a lead and plug must be connected to an earthed socket. Repairs and maintenance relating to safety or performance must be carried out by a qualified professional.
Technical data
See the type plate on the right hand side of the door.
CAUTION!
The lead must be disconnected or the socket
Connection to drainage
Connection to drainage
When the drain hose is routed to a connection nipple at the sink’s water trap (see illustration 1), note that the hose must be fastened level with the underside of the sink unit – otherwise the dishwater from the sink can run down into the dishwasher. The drain hose is threaded onto a
The drain hose may be lengthened by a maximum of 3 m (the total length of the drain hose may not exceed 4.5 m). Any connections and connecting pipes must have an internal diameter of at least 16 mm. However, the drain hose should ideally be replaced with a new hose without joins.
No part of the drain hose may be more than 950 mm above the bottom of the machine. The hose must not be routed directly to the floor drain or similar. In such cases, the hose can act as a siphon and empty the dishwasher.
The hose must always discharge at least 350 mm above the bottom of the machine.
NB!
The hose must be fastened level with the underside of the sink unit.
Illustration 1 | Illustration 2 |
Max 3 m |
Max 950 mm |
|
|
|
| Max 950 mm | |||||
|
|
|
| Min 350 mm | ||||||
Min 350 mm |
|
|
|
|
|
|
|
|
| |
Illustration 3
Max 950 mm
Min 350 mm
31