Extron electronic DVC501SD manual Rear Panel, Pin Signal

Rear Panel

The illustration below shows the connectors on the DVC 501 SD rear panel.

CAUTION: Use electrostatic discharge precautions (be electrically grounded) when making connections. Electrostatic discharge (ESD) can damage equipment, although you may not feel, see, or hear it.

WARNING: Remove power from the system before making any connections.

1	2	3	4	5		6
100-240V ~ 0.3A MAX	INPUT			OUTPUT
					AUDIO
	3G/HD/SD-SDI	BUFFERED	DVI-D	RGB/R-Y,Y,B-Y
		LOOP-THROUGH			L	R
						RS-232
50/60 Hz					N/A	Tx Rx

7

Figure 2. DVC 501 SD Rear Panel

AAC power connector — Plug a standard IEC power cord into this male IEC connector to connect the DVC to a 100 to 240 VAC, 50 Hz or 60 Hz power source.

B3G/HD/SD-SDI connector — Connect a 3G, HD-SDI, or SD-SDI source to this female BNC input connector.

CBuffered loop-through— This female BNC input connector passes a buffered 3G, HD-SDI, or SD-SDI signal through to a monitor or a video storage device.

DDVI-D output connector — Connect a DVI output device to this female single-link DVI-I connector (only the digital pins are enabled). RGB or YUV color space is available on this buffered output. The following table shows the pin assignments for this connector.

Pin	Signal	Pin	Signal	Pin	Signal
1	TMDS data 2–	9	TMDS data 1–	17	TMDS data 0–
2	TMDS data 2+	10	TMDS data 1+	18	TMDS data 0+
3	Ground (2/4 )	11	Ground (1/3)	19	Ground (0/5)
4	Not used	12	Not used	20	Not used
5	Not used	13	Not used	21	Not used
6	DDC clock	14	+5 V power	22	Ground (clock)
7	DDC data	15	Ground (for 5 V)	23	TMDS clock+
8	Not used	16	Hot plug detect	24	TMDS clock–

Figure 3. DVI-D Connector Pin Assignments

1 8

9 17 24

ERGB/YUV output connector — Connect an RGB (RGBHV, RGBS, RGsB) or YUV component (R-Y, Y, B-Y) display device to this female 15-pin HD connector. RGB or YUV color space is available on this buffered output.

DVC 501 SD • Installation 4