Sensor Replacement, Hi-Limit Switch Replacement

Disassembly Procedures

!WARNING

To avoid risk of electrical shock, personal injury or death, disconnect power to cooktop before servicing, unless testing requires power.

Sensor Replacement

1.Remove main top, see "Main Top Removal" procedure.

2.Remove screws securing element clips to main top.

3.Lower element and remove screws securing sensor to element.

4.Disconnect wiring to sensor.

5.Replace sensor and reverse procedure to reinstall.

Hi–Limit Switch Replacement

1.Remove main top, see "Main Top Removal" procedure.

2.Remove screws securing hi-limit switch to the mounting plate and remove hi-limit switch.

3.Disconnect and label wiring to hi-limit switch.

4.Replace hi-limit switch and reverse procedure to reinstall.

Limiter Replacement (Dual Element Only)

1.Remove main top, see "Main Top Removal" procedure.

2.Remove screws securing element clips to main top.

3.Lower element and remove screws securing limiter to element.

4.Disconnect and label wiring to limiter.

5.Replace limiter and reverse procedure to reinstall.

Indicator Light Replacement

1.Remove main top, see "Main Top Removal" procedure.

2.Remove screws securing mounting plate to main top.

3.Lift plate to access indicator light.

4.Depress tabs securing indicator light to mounting plate.

5.Transfer wires from failed light to replacement light.

6.Reverse procedure to reinstall new indicator light.

Infinite Switch Replacement

1.Remove main top, see "Main Top Removal" procedure.

2.Remove screws securing mounting plate to main top.

NOTE: An access panel is provided on the under side of the burner box for component diagnosis.

3.Lift plate to access switch mounting screws.

4.Remove screws securing switch to mounting plate.

5.Disconnect and label wiring to infinite switch.

6.Replace infinite switch and reverse procedure to reinstall.

Electronic Infinite Switch Replacement

1.Remove main top, see "Main Top Removal" procedure.

2.Remove screws securing mounting plate to main top.

NOTE: An access panel is provided on the under side of the burner box for component diagnosis.

3.Lift plate to access switch mounting nut.

4.Remove nut securing switch to mounting plate.

5.Depress tabs securing switch from bottom side.

6.Disconnect and label wiring to infinite switch.

7.Replace infinite switch and reverse procedure to reinstall.

Cooling Fan Replacement

1.Disconnect electricity to unit.

2.Remove knobs from valve stems.

NOTE: To remove knob(s), slide a rag under the knob and pull upward.

3.Remove cooktop from installation position and place face down on protected surface.

4.Remove screws securing bottom baffle to burner box bottom.

5.Remove baffle to gain access to fan.

6.Remove screws securing cooling fan to burner box bottom.

7.Disconnect and label wiring to cooling fan.

8.Replace cooling fan and reverse procedure to reinstall.

14	16022159 Rev. 0