TROUBLESHOOTING (Cont.)
SITUATION
The Pod Holder will not come out of the brewer.
EXPLANATION
The pod in the POD HOLDER may have swelled to a point where the holder does not slide out easily.
Wait at least 10 minutes and then try carefully removing the pod holder again. CAUTION: Hot liquid may be present.
Water is appearing on the counter around the base of the brewer.
Water leaks out around the sprayhead.
The WATER RESERVOIR has been removed to be filled with water and was not seated properly when it was replaced.
Remove the lid from the top of the brewer. With firm, but not forceful pressure, press down on both sides of the reservoir to ensure that the seal in the bottom of the reservoir seats properly. Replace the lid and watch for additional water around the base of the brewer. If a problem persists, contact Customer Service. (Refer to page 19 or 21 for customer assistance.)
Replace a damaged seal or tighten a loose sprayhead.
Refer to “Assembling The Sprayhead/Seal”
&“Inspecting The Sprayhead/Seal” sections for detailed information on how to resolve sprayhead leaks.
CAUTION: Wait for hot liquid to cool.
17