General Information

Improper installation could result in permanent damage and void the limited warranty. Read & follow the instructions on page 9.

•Use CAUTION when dispensing hot water from the brewer. The water from your BUNN® Pod brewer is approximately 93°C (200°F). This is approximately 10°C (50°F) hotter than the hot water from your faucet and must be handled with care.

•This brewer is designed to remain plugged in at all times (except during initial installation, cleaning, or when brewer will not be used for an extended period of time).

•A power switch is provided on the lower left side to completely shut off all electrical components when your plans take you away from the brewer for three or more days. Safety features, designed into the BUNN® Pod brewer, make the daily use of this switch unnecessary.

•Whenever the brewer has been shut off or unplugged for an extended period of time, rinse the reservoir and reﬁll with fresh cold water before using. It is also recommended that the brewer be cycled. (See page 14)

•Your BUNN® Pod brewer has a specially designed tank to keep the water inside at the proper temperature. This constant supply of hot water assures the correct method of brewing in less than one minute.

•When inserting a pod into the pod holder, it is important to seat the pod all the way into the holder cavity. Leaks could occur if the pod is too large, or does not seat completely into the holder cavity. Ensure that all of the paper edge and any tabs of the pod are inserted into the holder cavity.

•While brewing, the newest water in the tank is also being heated to the proper temperature and held until needed.

•International brewers are equipped with a 230 volt, grounded cord set. The plug is provided with a grounding circuit in compliance with local requirements. This is a safety feature and allows the plug to ﬁt into a properly grounded outlet. If the plug does not ﬁt into the outlet, contact an electrician to update your outlet. Attempting to bypass the safety aspect of this plug will void the warranty.

•The sprayhead may become loose over time. Unplug the machine and allow it to cool down before tightening or removing the sprayhead. Use extreme caution not to burn yourself. Tighten or remove the sprayhead with your ﬁngertips. (Refer to page 13)

•CAUTION: Never apply force to remove the pod holder. If the holder does not slide out easily, wait 10 minutes and try again. Burns resulting from hot water splash could occur if the holder is forcibly removed from the brewer.

•Use CAUTION to avoid burns during consumption of any freshly brewed beverage. Servings are extremely hot.

•To stop a brew cycle in process, press the Coffee or Tea button again. (See Page 7)

•When operating the brewer on a standard household outlet, do not attempt to power other appliances on the same circuit. Circuit overload could occur.

•Some noise is normal when the water pump is running during a brew cycle.