INITIAL BREWER SET-UP
1. Remove the lid and water reservoir.
P3017
(CAUTION: Do not place the brewer in a sink or other water source.)
2.Thoroughly rinse the water reservoir.
3.Fill the reservoir to the maximum line with
fresh cold water.
P2901
4. Replace the reservoir and li
and close the slide lid.
P2902
5. To ensure the Pod Holder |
|
is locked in place, use |
|
thumb to press the pod |
|
holder release button to |
|
eject the holder and then |
|
press all the way in to |
|
lock. | P2908 |
(CAUTION: You should hear a clicking sound when the pod holder locks in place.)
7. Plug in the brewer and turn on the power switch.
P0214/2905
8. | Place a mug or bowl that |
|
| will hold at least 414 ml (14 |
|
| fl. oz.) onto the drip tray |
|
| grate. | P2904 |
9. | Press and release |
|
| the coffee brew |
|
| button to fill the |
|
internal | water |
tank.* | P2907 |
(CAUTION: Water may not immediately flow from the brewer. Never remove pod holder from brewer during a brew cycle.)
10.Empty any water in the mug or bowl and place the mug back on the drip tray grate.
(NOTE: Wait for Heating Indicator to go out before proceeding to Step #11) 
11. Press and release 
the coffee brew 
button a second 
time.*
P2907
(CAUTION: Water should flow from the pod holder. Wait until water drip out has finished before removing the pod holder.)
6. Slide the volume 
control lever to 
the maximum 
setting.
P2952
You are now finished preparing the brewer for it’s first use. Proceed to the “Brewing Delicious Coffee Or Tea” section.
* Some noise is normal when the water pump is running.
9