Bunn GRX manual Brew through valve

Page 11

6.Cool the brewer by pouring a full decanter of fresh, cold water into the top of the brewer. Place decanter on the base plate and close the lid. When water has stopped flowing from the brewer, empty the decanter. Repeat this process and set the decanter aside.

7.Grasp the back of the brewer and turn it upside down over a sink. Most of the water in the tank will flow from the sprayhead tube opening. Some water may flow from the area around the top lid. Continue tipping the brewer until the flow stops.

8.Pour a decanter of water into the top of the brewer. Place the decanter on the base plate; close the lid and wait 3 minutes. Repeat this process with another decanter of water. Water will flow out of the funnel after the second decanter has been poured in. When flow from the funnel has stopped, empty the decanter and pour an additional decanter of water into the brewer. Place the decanter on the base plate and close lid.

9.Replace the sprayhead and funnel. Pour additional decanters of fresh, cold water into the brewer as needed until the water has no vinegar taste.

10.Place decanter on base plate and plug in the brewer. Allow the water in the tank to reach brewing temperature before using (approximately 15 minutes).

 

y

 

d o

i

 

u

D

?

 

k

 

now

 

While cleaning your brewer, don’t forget to check your glass decanter handle. If loose, use a standard screwdriver to tighten.

brew through valve

Thermal Carafe Routine Cleaning (BTX model) The carafe may be disassembled for cleaning. Rotate the lid counterclockwise to remove. Occasionally, the brew through valve

should be removed and cleaned. Lift at the edge and pull up. Use a mild, non-abrasive detergent to wash the lid thoroughly paying

particular attention to the passage where the brew through valve is located. After rinsing, replace the brew through valve into the carafe lid. Do not use a scrub pad or other abrasive cleaning device to clean the caraf , as this will scratch the stainless steel surface.

To remove coffee stains from inside the thermal carafe, place a paper filter in the funnel and pour in two teaspoons of Cascadepowder dishwasher detergent into the paper filter. Slide funnel onto the rails and open brewer lid. Pour one carafe of cold water into brewer. Position carafe on base plate of brewer and close lid. When brewing cycle has stopped, remove the brew funnel and discard the filter and detergent; rinse funnel thoroughly. Allow carafe to sit for 10-15 minutes. Using a long handled, soft bristled brush, clean inside of carafe as well as the outer rim to remove any coffee stains or debris. Occasionally scrub the carafe pour lip and the area around it, including the lid, with a mild detergent and warm water. Use a soft cloth and scrub hard. When finished, pour out solution into sink and thoroughly rinse carafe and lid with clean water.

9

Image 11
Contents Use and Care Manual Lid Stainless Steel Tank SpecificationsHigh Altitude USE Welcome Table of ContentsImportant Safeguards Hot, retighten the sprayhead with your fingertips General InformationSee steps on page 5 for brewing perfect coffee Slide empty funnel into funnel guides as shownNow, plug in the brewer Insert BUNN coffee filter into the brew funnel See page 4 for initial set up before brewingBrewing Perfect Coffee First timeBunn Brewing Difference Better BrewingBunn recommends you Avoid Bunn recommends you doProceed to Step Cleaning InstructionsBrew through valve For Service Information Contact Authorized ServiceBunn Accessories All the way Brewer leaks Brewers or call TroubleshootingProblemSuggestions Warmer switch should be in the on position. BX, GRX, NhbxLimited Warranty Récord para Mantenimiento de Limpieza Maintenance Cleaning RecordBunn-O-Matic Corporation