Bunn GRX manual General Information, Hot, retighten the sprayhead with your fingertips

Page 5

GENERAL INFORMATION

Improper set up will result in permanent damage and void the limited warranty. Read and follow the initial set up instructions on page 4.

This brewer is designed to remain plugged in at all times, except during initial set up or when cleaning.

A vacation switch is provided on the lower side to completely shut off all electrical components when your plans take you away from home for three or more days. Safety

features that are designed into the BUNN coffee brewer make the daily use of this switch unnecessary. Press I to turn on and press O to turn off.

If the brewer has been shut off or unplugged for an extended period of time, fill the tank with water and allow the water in the tank to heat to the proper temperature before using (about 15 minutes or until the heating sound stops).

Your BUNN coffee brewer has a specially designed hot water tank to keep the water at the proper temperature. This constant supply of hot water assures correctly brewed coffee in less than three minutes.

(BTX models) The brewed coffee flows into an unheated thermal carafe. The double wall stainless steel construction will hold coffee at serving temperature for about two hours at maximum flavor. Pre-heating with hot water will increase the time your coffee stays warm.

(GRX, BX and NHBX models) The brewed coffee flows into a glass decanter where it is kept at serving temperature on the porcelain decanter warmer. The warmer is controlled by the lighted on/off switch on the front of the brewer.

NOTE: The warmer switch controls only the decanter warmer.

The decanter lid reduces coffee evaporation and temperature loss.

While coffee is being brewed, the newest water in the tank is heated to the proper temperature and held until needed.

When the brewer is not in operation, the lid should be closed. If the lid is left open, water could drip from the sprayhead when cold water is poured in.

Use CAUTION when dispensing hot water from the brewer. The water is approximately 50°F hotter than what’s available from your hot water faucet and is always available for other uses.

The sprayhead may periodically become loose. Using extreme caution since it may be

hot, retighten the sprayhead with your fingertips.

NOTE: A severe burn may result if the sprayhead becomes loose and falls off while the coffee is brewing.

HOT WATER

 

y

 

d o

i

 

u

D

?

 

k

 

now

 

Get hot water anytime. Just leave out the paper filter and coffee from the brew funnel. With funnel in place, pour cold water into brewer and in just minutes you will have hot water.

3

Image 5
Contents Use and Care Manual Lid Stainless Steel Tank SpecificationsHigh Altitude USE Welcome Table of ContentsImportant Safeguards Hot, retighten the sprayhead with your fingertips General InformationSee steps on page 5 for brewing perfect coffee Slide empty funnel into funnel guides as shownNow, plug in the brewer Brewing Perfect Coffee See page 4 for initial set up before brewingFirst time Insert BUNN coffee filter into the brew funnelBunn Brewing Difference Better BrewingBunn recommends you Avoid Bunn recommends you doProceed to Step Cleaning InstructionsBrew through valve For Service Information Contact Authorized ServiceBunn Accessories ProblemSuggestions TroubleshootingWarmer switch should be in the on position. BX, GRX, Nhbx All the way Brewer leaks Brewers or callLimited Warranty Récord para Mantenimiento de Limpieza Maintenance Cleaning RecordBunn-O-Matic Corporation