Initial Set Up Guide
IMPORTANT:
Brewer is NOT ready to plug in until you have followed the steps below. Do NOT plug in brewer until step #5.
NHBX BTX/BX/GRX
1.Slide empty funnel into funnel guides as shown.
2.Fill decanter with cold water. Swivel or lift brewer lid and pour water into brewer. Position decanter on base below funnel. Close the lid and wait three minutes while the internal tank partially fills.
3.Open the lid. Remove decanter and fill with cold water again. Pour water into brewer. Position decanter on base under funnel and close the lid.
4.Wait until water flows from the funnel. When water flow stops, pour out any water that has collected in the decanter. Replace decanter on brewer below the funnel.
5.Now, plug in the brewer.
6.Press the bottom of the vacation switch, located on the side of the brewer, to turn unit on (Press I to turn on and press O to turn off.) Wait 15 minutes for the water in the tank to heat.
UN N
See steps on page 5 for brewing perfect coffee.
4