DRAINING THE hot water tank
CAUTION - The dispenser must be disconnected from the power source throughout these steps.
1.Disconnect the dispenser from the power source.
2.Open front door and place tank heater switch in the “OFF” (upper) position.
3.Shut off and disconnect the incoming water supply.
4.Remove the top panel.
5.Gently remove one of the grommets from the tank lid.
6.Insert a tube to the bottom of the tank and syphon ALL of the water out.
NOTE - The dispenser must be refilled using the INITIAL FILL & HEAT steps before reconnecting to the power source.
PREVENTIVE MAINTENANCE
NOTE: Replacement parts or service caused by failure to perform required maintenance is not covered by warranty.
Cycle | Item | Part Number | |
(months) | |||
6 | Mixing Chamber Kit | 32906.0000 | |
| |||
|
|
| |
6 | Whipper Motor Seal Kit | 29128.0000 | |
| |||
|
|
| |
3 or as | Whipper Shaft Seal Kit | 26356.1000 | |
needed | |||
|
|
9 | 29170 011510 |
|