Breville BWC200 manual LED Indicator, Adjusting the Water Temperature, Setting the BRita Memo

operating YOUR BREVILLE Chill control™

operating YOUR BREVILLE Chill control™

2.Immerse the filter cartridge in cold water and agitate gently to remove any air bubbles.

LED Indicator

The WHITE light will turn On first to indicate the appliance is in cooling mode.

When the water inside the cooling reservoir has chilled (approximately 75 minutes ) the LED indicator will change to BLUE.

In warmer climates the time to chill will take longer.

Adjusting the Water

Temperature

NOTE

We recommend you change the BRITA‰ MAXTRA filter every 8 weeks.

Replacement filters can be purchased through major retail outlets or via store.brita.com.au.

For additional questions on the BRITA replacement filters, please contact BRITA Consumer Service on 1300 557 762.

Setting the BRita® Memo

Once you have fitted and prepared your filter cartridge, start the BRITA‰ Memo as follows:

1.Press and hold the START button until 4 bars appear on the display and flash twice. The filter replacement reminder is now set.

2.The flashing dot in the corner of the display indicates the filter replacement reminder is working.

3.Insert the cartridge into the cartridge housing of the pre-filter tank and push firmly into place until it clicks into position.

4.Take the pre-filter tank out of the water tank, fill it under the tap with cold tap water and allow it to filter through. Discard the first two fillings. They are used to flush the filter cartridge.

5.Place the pre-filter tank back into the unit and refill with water. Ensure the water is always above the minimum level for optimum flow rate.

6.The Breville Chill Control™ is now ready for use.

NOTE

Repeat the above process every time you insert a new cartridge.

7.Once the water has been filtered, the pre-filter tank can be refilled. Water will filter through as it dispensed into the filter tank water.

It will take 6 minutes on average to filter 1 litre of water through the BRITA‰ MAXTRA cartridge.

The variable temperature slider allows you to adjust the temperature of filtered water to suit your taste.

The temperature of the water will vary depending on the selection made.

Slide the lever to the far left for the coldest setting or to the right for room temperature filtered water.

A selection in the middle will give you filtered water somewhere between chilled and room temperature.

NOTE

The LED indicator does not change colour when adjusting the variable temperature control slider.

NOTE

If dispensing more than 1 litre of chilled water at one time, it will take approximately 75 minutes for another litre of water to be chilled to minimum temp.

AUTO PRotection MODE

If there is an error with internal electronics or the fan is externally obstructed, the LED will start to flash, alternating between BLUE and WHITE and the appliance will enter into auto protection mode.

To reset the appliance, unplug the unit from the power outlet, wait for a few minutes until the LED stops flashing, and plug back into power outlet.

If the LED continues to flash once reset, contact Breville Customer Service

1300 139 798 for further assistance.

Using the BRita® Memo

It is important to change your filter cartridge regularly to enjoy the benefits of filtered water.

The BRITA‰ Memo (electronic exchange indicator) reminds you when your filter cartridge needs to be changed. It is automatically calibrated according to average use of 1 litre of water per day and will remind you to change your filter every 8 weeks.

3.At the end of every 2 weeks, 1 bar will disappear indicating the remaining cartridge life. Ensure you have a new replacement BRITA‰ MAXTRA water filter cartridge available when only 1 bar is showing.

10 11