Installation
If necessary the included 6 metre water hose can be cut down to the required length using a sharp knife. You should ensure no burrs are left on the hose.
The water connection fitting and flow reducer are prefitted However, if you should need to reconnect the fitting, proceed as follows:
Connect one push fit tap adaptor to each end of the water hose.
Insert the supplied flow restrictor and black
Secure the tap adaptor that does not contain the flow restrictor to the valve on the back of the appliance and then connect the remaining tap adaptor to the mains water supply tap.
Once both tap adaptors are securely fitted turn on the water supply and check for leaks.
Please note:
Due to the weight of this appliance, the housing unit must be secured to the wall prior to installation.
You must ensure that all water connections are sound and check there are no leaks before completing installation.
For best performance, the mains water pressure must be between 0.1 - 3 bar. Do not use outdoors.
Do not install near a hob or oven.
To reduce the risk of electric shock, do not mount over a sink.
fig. 4
i |
|
Flow restrictor | fig. 5 |
|
fig. 6