The Icemaker
Before first use:
1.Pull the machine out of its housing by lifting the handle of the machine and pulling it towards you.
2.Fill the water tank (even if the appliance is to be plumbed in to the mains water supply).
3.Turn on the machine at the switch on the left side of the machine.
4.Push the machine back into the housing.
5.Switch on the machine by pressing the ON button.
6 The machine is now ready for use and the display shows ICE ON WATER READY.
The water tank
It is possible to use the appliance without connecting it to the mains water supply. There is an integral water tank which can be used in this instance. To ensure the best results from your appliance, it is recommended that the water tank be emptied frequently and refilled with fresh water, and no water be left in the tank for long periods.
When the water tank is empty, the message WATER MISSING will show on the display.
To fill the water tank:
1.Pull the machine out of its housing by lifting the handle of the machine and pulling it towards you.
2.Open the lid of the water tank and fill it until the water is 4cm from the top level. Then close the lid.
3.Push the machine back into the housing.
Please note:
You should follow the steps below in order to remove any impurities from the system and ensure best performance from your ice maker. Failure to carry out this simple procedure could cause problems or damage to the workings of the icemaker.
1.Turn off the mains water supply, if applicable
2.Use a sterilising solution such as Milton fluid to clean the removable ice drawer and the ice drawer housing. Follow the instructions supplied with the sterilising solution to ensure the ice drawer is thoroughly cleaned.
3.Fill the internal water tank with 2.5l of water then add a spoonful of bicarbonate of soda to the water.
4.Use the water empty function (press and hold
and 
, then press 
before emptying the water tank by holding
) to flush the system through with the bicarbonate solution from the water tank.
5.Repeat steps 3 and 4.
6.Fill the water tank with 2.5l of water
7.Use the water empty function (press and hold
and 
, then press 
before emptying the water tank by holding 
) to clear out any bicarbonate solution remaining.
8.Repeat steps 6 and 7.
9.Turn the ice maker off
10.Turn the mains water supply back on, if applicable, or fill the water tank.
11.Turn the ice maker on. Normal operation will resume.