Before Using the Warming Drawer
When using the appliance for the first time, clean it as follows:
•Clean the surface with a damp cloth, then dry.
•Preheat the empty drawer for at least 2 hours: turn the temperature knob to the max. position in order to eliminate any manufacturing residuals (grease, oil or resins) which could cause unpleasant odours during cooking. Air the room.
•After carrying out this simple operation, the appliance will be ready for first use.
Before using the appliance, remove:
•Stickers on the front and warming drawer door, except the rating plate;
•Cardboard protection and protective plastic film from all the aesthetic parts, if present. and from the front panel controls and other parts of the warming drawer;
•Any stickers from the accessories if present.
Installation
Important : The warming drawer must be immediately fixed to the cabinet, complying with the following instructions. Do not install the combined electrical appliance provided for, before fixing the warming drawer to the cabinet.
Spacers : fix the drawer as shown opposite.
Note : should it be necessary to align the appliance aesthetically with other combinations of product, the drip tray at the bottom can be removed and eliminated by unfastening the two fixing screws.
•Before connecting the appliance to the power supply, compare the connection data (voltage and frequency) given on the dataplate with that of the electrical mains.
•The data must match, otherwise the appliance could become damaged.
•In case of doubt, contact a qualified technician.
•Make sure the socket can be easily accessed even after the appliance has been fitted.
•The warming drawer can only be fitted in combination with other appliances not weighing more than 40 kg and provided with adequate cooling ventilation. Otherwise, the right to the warranty is invalidated, since correct use cannot be guaranteed.
•For combined appliance installation comply with the instructions given in the relevant use and installation handbook.
•Fitting and installation of this appliance must only be carried out by qualified personnel who guarantee that the requirements for safe use are met.
Measurements
•All measurements are given in mm.