CDA RC9301 manual Electrical installation, For your safety please read the following information

Page 40

Electrical installation

For your safety please read the following information:

This appliance must be installed by a qualified technician according with the current local regulations and in compliance with the manufacturer instructions.

This appliance is supplied with a moulded 13 amp three pin mains plug with a 3 amp fuse fitted. Should the fuse require replacement, it must be replaced with a fuse rated at 3 amp and approved by ASTA or BSI to BS 1362.

The plug contains a removable fuse cover that must be refitted when the fuse is replaced. In the event of the fuse cover being lost or damaged, the plug must not be used until a replacement cover has been obtained.

Replacement fuse covers can be purchased from your nearest electrical dealer and must be the sarne colour as the original.

IF THE MOULDED MAINS PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR HOME OR IS REMOVED FOR ANY OTHER REASON, THEN THE FUSE SHOULD BE REMOVED AND THE CUT OFF PLUG DISPOSED OF SAFELY TO PREVENT THE HAZARD OF ELECTRIC SHOCK.

THERE IS A DANGER OF ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 13 AMP SOCKET OUTLET.

If a replacement plug is to be fitted, please observe the wiring code shown below.

Warning! This appliance must be earthed

A properly earthed three pin plug (fused at 3 amps, to BS 1362 ASTA approved) must be used.

As the colours of the wires in the mains

Green & Yellow

lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows.

The wire which is coloured GREEN & YELLOW must be connected to the terminal in the plug which is marked with letter "E" or by the Earth symbol or coloured GREEN & YELLOW.

Earth

3 amp fuse

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter "N" or coloured

BLACK.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter "L" or coloured RED.

Blue Neutral

 

Brown Live

 

 

 

Fig. 47

40

Image 40
Contents RC9301 Single Cavity Gas Cooker CDA Contents Introduction Assembling the backguardFeatures and technical data Gas burnersMinute counter Control panelMinute counter Hob burners How to use the hob burnersLighting of the hob burners Choice of burner Burners Pan diameterCorrect use of triple-ring burner How to use the gas oven Lighting the oven gas burnerOven ThermostatOven cooking temperatures How to use the gas grill Lighting the grill gas burnerOven light Important WarningRotisserie Use of the rotisserieDo’s and do not’s Do’s and do not’sImportant notes For your safetyOven door guard Care and maintenance Cleaning the hobFlexible tube Gas tapsEnamelled parts Changing the oven lightBurners Triple ring burnerRemoval of the inner glass door panel Storage compartmentAssembling and dismantling of the side runner frames Inside of ovenOven floor Door assembly Removing the oven doorFor Installer Location Fitting the adjustable feet Levelling the cooker Stability bracket Provison for ventilation Gas installation Important NoteInstallation to Natural Gas Gas connectionPlug 200 mm 700 mm Injectors replacement of top burners Conversion to Natural Gas or to LPGAdjusting of the minimum of the top burners Table for the choice of the injectors Cat II 2H3+Replacement of the oven burner injector Replacement of the grill burner injector Primary air of the oven burner Primary air of the grill burnerLubrication of the gas taps Regulating of the oven minimumElectrical installation For your safety please read the following informationElectrical feeder cable connection Feeder cable section type H05RRFAppliance servicing Guarantee Limit of CoverRC 9301 .. cookers