Pyrolysis Programmes
This oven can clean itself by a process known as pyrolysis, heating the cavity to a temperature of 420˚C. This will burn
off the residue from spattering and spillages caused by cooking.
Pyrolytic programmes should be used when the oven smokes during preheating or cooking or if the oven smells even
when cold. It is not necessary to run a pyrolytic programme after every use of the oven, as shown in the table below.
Do not wait until the oven is coated in grease to run a pyrolytic programme.
The smoke produced by pyrolysis is broken down by passing through a catalyser.
Amount of residue | Type of food cooked | Frequency of pyrolysis |
|
|
|
Light | Biscuits, vegetables, pastry | Not required |
|
|
|
Medium | Meats, fish, stuffed vegetables | Every three uses. |
|
|
|
Heavy | Joints of meat on the rotisserie | After each use if there was extensive splattering |
|
|
|
This oven has 3 pyrolytic programmes:
Pyrolysis – 2 hour programme
Pyrolysis ECO – 1 hour 30 minute programme
Optimum Pyrolysis – a variable programme between 1 hour 30 minutes and 2 hours 15 minutes. The oven will automatically determine the length of the programme depending on the condition of the oven.
All three programmes can be run immediately or as a delayed programme.
Please note: Before any pyrolytic programme, remove all shelves, trays and other accessories from the oven and clean up any major spills. The side grills and grill pan tray are specially coated in pyrolytic enamel and are safe to leave in the oven during pyrolysis.
Touch 
Touch 
once for Pyrolysis, twice for Pyrolysis ECO or three times for Optimum Pyrolysis. The programme selected will flash on the display (B in figure X)
To set a delayed pyrolytic programme, touch 
. The display will flash 
.
Touch 
or 
until the required end time shows on display, then touch 
to confirm the timer selection.
Touch 
to start the programme – the programme time cannot be modified.
The programme begins immediately. The display stops flashing and the temperature symbol lights up. During the programme, the 
is shown on the display to indicate the door is locked.
At the end of the programme, the timer display flashes 0:00.
11