Troubleshooting
If the oven is not functioning correctly, check the advice below prior to calling CDA Customer Care.
Problem | Possible Cause | Advice | |
|
|
| |
|
| Check the oven is switched on at the | |
The oven does not heat up | There is no power supply to the oven | cooker point and the fuse/circuit | |
|
| breaker has not activated. | |
|
|
| |
The padlock on the display is flashing | Door lock system fault | Call CDA Customer Care | |
|
|
| |
The oven light is not working | Light fault | Call CDA Customer Care | |
|
|
| |
The pyrolysis programmes do not start | The door is not properly closed | Close the door completely | |
|
| ||
Door lock system fault | Call CDA Customer Care | ||
| |||
|
|
| |
The oven starts beeping during cooking |
| The oven is at the required temperature | |
|
|
| |
The oven starts beeping at the end of |
| The programme has finished | |
the cooking programme |
| ||
|
| ||
|
|
| |
|
| The fan will run up to one hour after | |
|
| cooking, or when the oven temperature | |
The cooling fan continues to run after |
| is above 125˚C | |
|
| ||
the programme ends |
| If the fan continues to run more than | |
|
| ||
|
| 90 minutes after use, then call CDA | |
|
| Customer Care | |
|
|
|
The oven display will show error codes if there is a fault with the appliance. These are detailed below. Before calling CDA Customer Care, take note of the error code as this will help when attempting to resolve the problem.
Error Code | Fault | |
|
| |
F01 | Temperature sensor error | |
|
| |
F02 | Overheated oven . First ensure there is adequate ventilation to the oven as described on page 16. | |
|
| |
F03 | Pyrolysis failure (door locked) | |
|
| |
F04 | Door interlock | |
|
| |
F05 | Other cooking fault | |
|
| |
F10 | Information only – power cut during cooking | |
|
| |
AUTO | Auto stop. The oven is equipped with an auto stop function to automatically switch off the oven if it is in | |
continuous use for more than 23 hours and 30 minutes. | ||
| ||
|
|
15