About the water filtration system.
Filter Cartridge Installation or Replacement
CAUTION: Never remove the sumps when water pressure is in the Water Filtration system.
1 Close the water supply/saddle valve to the filter.
(See illustration in the Installation Overview section for location of the water supply valve.) Open the filtered water faucet.
2 Remove the sump, using the sump wrench tool provided, from the filter head by rotating the sump as shown in the below illustration.
Be careful, the sump may be full of water. Be sure to keep the large
3 If you are replacing a filter cartridge, remove and discard the used filter cartridge.
4 Be sure the inside of the sump is clean. Thoroughly wash the inside of the sump with hot, soapy water and rinse.
5 Remove the wrapper from the new filter cartridge and insert the filter cartridge in the sump. Some cartridges fit either way, while others fit only one way. Observe markings on the cartridge.
NOTE: The Water Filtration system may use two different types of filter cartridges. Be sure to install them correctly. Filter I cartridge should always be placed in the Filter I sump. Filter II cartridge should always be placed in the Filter II sump. See page 3 for a complete list of filter performance characteristics.
Turn sump wrench tool provided clockwise to remove sump
INLET
Cartridge
Sump I
Label
TURN SUMP
TO REMOVE
Filter I
Sump
Bracket
OUTLET
Head
Sump II
TURN SUMP
TO INSTALL
Filter II
For Model GN1S15CBL | For Model GNSL05CBL | |
(rev. 2) | (rev. 2) | |
FXULC (rev. 2) Filter | FXSLC (rev. 2) Filter | |
Set | ||
Filter – White with | ||
Filter I – White with no | ||
yellow end caps | ||
| end caps | |
| Filter II – White with | |
| yellow end caps |
For Models GNSV25CBL, GNSV30CWW & GNSV30CCC
FXSVC (rev. 2) Filter Set
Filter I – White with green end caps Filter II – Gray
10