Ariston FM 51 IX GB Installation of Built-in Ovens, It is a good idea to do the following

-Allowing power supply cords for small appliances to come into contact with the hot parts of the appliance;

-Exposing the appliance to atmospheric agents (rain, sun);

-Using the oven for storage purposes;

-Using flammable liquids near the appliance;

-Using adaptors, multiple sockets and/or extension cords;

-Attempting to install or repair the appliance without the assistance of qualified personnel.

Qualified personnel must be contacted in the following cases:

-Installation (following the manufacturer's instructions);

-When in doubt about operating the appliance;

-Replacing the electrical outlet when it is not compatible with the plug for the appliance.

Service Centres authorized by the manufacturer must be contacted in the following cases:

-If in doubt about the soundness of the appliance after removing it from the packaging;

-If the power supply cord has been damaged or needs to be replaced;

-If the appliance breaks down or functions poorly; ask for original spare parts.

It is a good idea to do the following:

-Only use the appliance to cook food, nothing else;

-Check the soundness of the appliance after it has been unpacked;

-disconnect the appliance from the electrical mains if it is not functioning properly and before cleaning or performing maintenance;

-When the appliance is not used for an extended period of time, cut off the supply of power and close the gas cock (if present);

-Use cooking gloves to place cookware in the oven or when removing it;

-Always grasp the oven door in the centre because the ends may be hot due to the escape of hot air;

-Make sure that the control knobs are on the “•”/”o” setting when the appliance is not in use;

-Cut the power supply chord after disconnecting it from the mains when you decide not to use the appliance any longer.

•The manufacturer will not be held liable for any damages that might arise out of incorrect installation or improper, incorrect or unreasonable use of the appliance.

Installation

Important: The power supply to the appliance must be cut off before any adjustments or maintenance work is done on it.

Installation of Built-in Ovens

In order to insure that the built-in appliance functions properly, the cabinet containing it must be appropriate. The figure below gives the dimensions of the cutout for installation under the counter or in a cabinet wall unit.

			mm.23				.	mm.
					45	mm
mm.595				mm.567		558	mm.	593
			5 mm.
	595	mm.		.
			543	mm
		.
		mm
	20

	.
45	mm
	.
min

In order to ensure adequate ventilation, the back panel of the cabinet must be removed. Installing the oven so that it rests on two strips of wood is preferable.

In the case where the oven rests on a continuous, flat surface, there must be an aperture of at least 45 x 560 mm.

.	45	mm.
mm
560

To fasten the oven to the cabinet, open the door of the oven and fasten it by inserting the 4 wood screws into the 4 holes locate on the perimeter of the frame.

595 mm.	23 mm.
	567 mm.
	5 mm.

595	mm.		.
		543	mm
	.
	mm
20

558 mm.

-585 mm.	595 mm.
575

	.
	mm
45	.
	min

The panels of the adjacent cabinets must be made of heat resistant material. In particular, cabinets with a veneer exterior must be assembled with glues able to withstand temperatures of up to 100° C.

In compliance with current safety standards, contact with the electrical parts of the oven must not be possible once it has been installed.

All parts which ensure safe operation of the appliance must

6