1. | Remove two screws from one side of the unit. Retain the |
| screws for possible future use. |
2. | Attach one bracket to the side of the unit, using the |
| provided machine screws. |
3. | Repeat steps 1 and 2 on the other side of the unit. |
4. | Hold the PA 300 with the attached brackets against the |
| mounting location. On the mounting surface, mark the |
| location of the four bracket screw holes. |
5. | Drill pilot holes 1/4" (6.4 mm) deep and 3/32" (2.4 mm) |
| in diameter in the desk or table at the locations of the |
| mounting bracket screws. The holes should be drilled |
| from the underside or inside (concealed side) of the |
| furniture, where the amplifier will be located. |
6. | Insert #8 wood screws into the four pilot holes. Tighten |
| each screw into the mounting surface until slightly less |
| than 1/4" of the screw head protrudes. |
7. | Align the mounting screws with the slots in the brackets |
| and place the unit against the surface, with the screws |
| through the bracket slots. |
8. | Slide the unit slightly forward or back, then tighten all four |
| screws to secure it in place. |
PA 300 Peaking Amplifier • Installation and Operation |