Extron electronic PA 300 user manual Through-desk mounting the PA

Installation and Operation, cont’d

Through-desk mounting

Mount the PA 300 through a desk or table, using the optional mounting kit (part #70-077-02), as illustrated below.

Through-desk mounting the PA 300

1.	Install the brackets as shown above. Tighten the screws
	only enough to allow sliding of the brackets.
2.	Mark the opening through which the unit will be mounted
	— approximately 1.8" by 8.9" (4.6 cm by 22.6 cm).
3.	Cut out the material from the installation area.
4.	Hold the unit, with the mounting brackets attached, under
	the furniture where it will be secured. Mark where the
	screws will attach the mounting bracket to the underside
	of the furniture.
5.	Drill pilot holes 1/4" (6.4 mm) deep and 3/32" (2.4 mm)
	in diameter in the desk or table at the locations marked in
	step 4.
6.	Using the four provided wood screws, attach the brackets
	to the mounting surface.
7.	Slide the unit up and down or back and forth in the
	mounting brackets until the face of the PA 300 is at the
	desired height. Tighten the screws that secure the brackets
	to the unit.

2-6 PA 300 Peaking Amplifier • Installation and Operation