Haier WQP12-CBE3 manual Wash Cycle Table Energy Saving Tips, Cleaning and Special Maintenance

Wash Cycle Table GB

Energy Saving Tips GB

-It is important to try and run the dishwasher when it is fully loaded in order to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the hold cycle.

-Use the right amount of detergent: if you use too much deter- gent, the result will not be cleaner dishes, but, rather, a greater negative impact on the environment.

Cycle

Cycle Selection

Description of	Detergent	Rinse Aid
Cycle

-Choose the right wash cycle: the choice of cycle depends on the type of dishware, cookware and utensils being washed and how dirty they are.

-There is no advantage in rinsing dishes, cookware and utensils before placing them in the dishwasher.

Information

Pre-wash with hot water.

How to keep Your Dishwasher in Shape

Heavy Duty

Normal Wash

(IEC-EN50242)

Very dirty dishes, pots and pans. (Not to be used with deli- cate items)

Normally dirty dishes, pots and pans. Stan- dard daily cycle.

Normally dirty dishes, pots and pans without dried on residue.

Extended wash at 70
Rinse with cold water.	30g
Rinse with hot water at 70
Drying.
The second pre-wash use cold
water.
Extended wash at 55 .	30g
Rinse with cold water.
Rinse with hot water at 70 .
Drying.
Pre-wash with cold water.
Extended wash at 55
Rinse with cold water.	30g
Rinse with hot water at 70
Drying.

After Every WashWhen You Go on Holiday

After every wash, turn off the water supply to the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside.

Remove the plug

When you go on holiday, it is recommended that you run a wash cycle with the dishwasher empty and then remove the plug from the socket, turn off the water supply and leave the door of the appliance slightly ajar. This will help the seals last longer and prevent odors from forming within the appliance.

Before cleaning or performing maintenance, always remove the plug from the socket. Do not run risks.

Moving the Appliance

No solvents or Abrasive Cleaning Products

If the appliance must be moved, try to keep it in a vertical position.

If absolutely necessary, it can be positioned on its back.

To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning products. Rather, use only a cloth and warm soapy water.

Seals

To remove spots or stains from the surface of the interior, use a cloth dampened with water and a little while vinegar, or cleaning product made specifically for dishwashers.

One of the factors that cause odors to form in the dishwasher is food that remains trapped in the seals. Periodic cleaning with a damp sponge will prevent this from occurring.

Light Wash

Glassware

Rapid Wash

Economic, fast cycle to be used for items which are sensitive to height. Run immediately after dishes are used.

Economic, fast cycle to be used to on not very dirty dishes right after they are used. No dry- ing cycle.

Wash at 50 .
Rinse with warm water.	15g
Hot rinse at 70 .
Drying.
Short wash at 50 .	15g
Cold rinse.

Cleaning and Special Maintenance

Filter Assembly

For best performance and results, the filter assembly must be cleaned frequently.

The filter efficiently removes food residue from the wash water, allowing it to be recirculated during the cycle. For this reason ,it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing the "A" semicircular filter and cup under running water. To remove the filter assembly, pull on the cup handle in the upward direction. The entire filter as- sembly (made up of the "A" semicircular filter and the "B" fine filter) should be cleaned at least once a week.

To clean the filter and the fine filter, use a cleaning brush .Then, reassemble the filter parts as shown in the figures below and reinsert the entire assembly in the dishwasher, positioning in its seat and pressing downward.

The dishwasher must never be used without the filters. Improper replacement of the filters may re- duce level of the appliance and damage dishes and utensils.

Cleaning the Spray Arms

It may happen that food particle become encrusted on the spray arms and block the holes. Check the spray arms periodically and clean them when needed.

A

B

Cleaning the Water Inlet Filter

Periodically clean the water inlet filter (see figure) located on the outlet of the water supply tap.

After turning off the water tap, unscrew the end of the water sup- ply hose, remove the filter and clean it carefully under running water. Then, return the filter to its place and tighten the water supply hose back into position.

.7. .8.