Haier HDF-245SD, HDF-345SD Energy Saving Tips, Operating Your Freezer, Voltage supply, Power Cut

Page 6
Energy Saving Tips

Energy Saving Tips

3) A 13 Amp, 3 Pin Plug and 5 Amp fuse only must be used for this freezer to avoid serious damage. The plug should always be wired in accordance with the following codes.

Green and Yellow

Earth (E)

Blue

Neutral (N)

Brown

Live (L)

It is safest to consult a qualified electrician at all times.

4) In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electrical current. This appliance is fitted with a cord having a grounding wire with a grounding plug. This plug must be plugged in to an outlet that has been properly installed and grounded.

5) Consult a qualified electrician or service centre if the grounding instructions are not completely understood or if any doubt exist as to whether the appliance is properly grounded.

Energy Saving Tips

* Do not place your freezer nest to a heating vent, cooker, in direct sunlight or in the vicinity of any other heat-producing source.

* Deep the door closed as much as possible, especially in hot and humid weather.

* Defrost the freezer every few months or when the frost becomes 6mm (1/4") thick or more.

* Cover foods securely to reduce moisture build up inside the freezer.

7

Operating Your Freezer

Voltage supply

To start your freezer it must be connected to a 220 volt, 50 Hz A.C. power supply. Failure to do so may invalidate the guarantee.

Once the freezer is properly plugged in, the green power light will illuminate, indicating that the freezer is in operation.

Temperature/Cold Control

The temperature control dial has settings from "1"-"7". Where "1" is the warmest and "7" is the coldest temperature setting. Turn the control knob to higher numbers for colder temperatures.

During extremely hot weather and frequent lid opening, it is advisable to select a higher setting to ensure that food remains frozen.

Initially, set the temperature control knob to the "5" setting by turning the knob in a clock wise direction. After 30 minutes, you should notice an obvious decrease in the interior temperature of the freezer.

Let the freezer to run for a further 12 hours before placing your food inside, allowing some space between items to allow air to circulate properly. After using the freezer for 24 hours, adjust the temperature control to the setting that is best suited to your need.

Power Cut

If you unplug your freezer or experience an electrical outage, ideally wait five minutes before plugging the appliance back in.

8

Image 6
Contents Deep Freezer OPERATING MANUALWarranty Card inside Inspired livingService Centres UAN 11 11 HAIER service@haier.com.pkParts Table of ContentsImportant Safeguards PAGEDANGER Freezer Installation Electric Control PanelE l e c t r i c C o n n e c t i o n a n d Precautions Power Cut Energy Saving TipsOperating Your Freezer It is safest to consult a qualified electrician at all timesFast/Quick Freeze Switch Care & CleaningHOW TO CLEAN Lamp Control SwitchCleaning and temperature setting DefrostingUseful Hints DefrostingTroubleshooting TroubleshootingSafety Notes Troubles/ProblemTroubleshooting