Electric Control Panel

The main functions of the electronic control panel are:

1) The control panel is numbered				-1
1,2,3,4,5,6,7. This refers to the
temperature on the inside of
the freezer. The temperature is
lowered by turning the dial in
clockwise direction.
Refrigerate: When dial is near the "1"
position,	the	interior	average
t e m p e r a t u r e o f f r e e z e r i s
approximately 10 C ~ -2 C.
Freeze: When dial is near the "2-7"
position,	the	interior	average

t e m p e r a t u r e o f f r e e z e r i s approximately -2 C~ -26 C.

When you change the dial from refrigerate function to freeze function, the food in the freezer should be taken out to avoid freeze.

2)	The	green lamp indicates					that	-2
	the appliance is connected to a

	power supply. The green lamp
	illuminates when the freezer is
	connected		to an		appropriate
	power supply.
3)	The	yellow		lamp	illuminates			-3
	when the			"Quick Freeze"
	function		is	working.		Quick
freezing can retain the original						taste
of the food.
4)	All	con tro l		e quipment			is	-4

installed on the control panel situated on the exterior of the freezer.

Freezer Installation

1) The freezer is designed for free- standing installation only.

2) Install the freezer on a base strong enough to support it when fully loaded. Ensure the freezer is on a stable surface to minimize noise and vibration.

3) When moving the freezer, never tilt at an angle more that 45 as t h i s c o u l d d a m a g e t h e compressor and freezer system. If the freezer is tilted over 45 , or has been stored on its side, allow the freezer to stand upright for at least 24' hours prior to plugging it back in, this will allow the refrigerant to settle.

4) Install the freezer in a well- ventilated area away from any heat source or direct sunlight. Air must be allowed to circulate freely around the freezer. Allow at least 3 inches (7.5 cm) of clearance space for the top, back and sides.

5)Install the freezer in a dry place

to prevent rust from forming on the compartment body and to avoid the risk of damaging the electric insulation.

E l e c t r i c C o n n e c t i o n a n d

Precautions

1)IMPORTANT: For personal safety,

this appliance must be properly earthed.

2) The rated voltage for this appliance is 220V to 240V. In the event that your regional power supplier connot meet this requirement, please use a safe and reliable automatic voltage regulator with a minimum output of 500W to avoid damaging the compressor.