2.If seismic safety lines are being used, install them now. In addition to the tie off at 4c,
Extron recommends tie offs on at least two at the four available tabs at 4e. See the illustration below.
4f | Anchor the safety cables | |
to a suitable secure point. | ||
|
4c | Attach a safety cable |
| to a line retainer loop |
| at either 4c or 4d. |
4d |
|
Seismic
Safety
Cable
Bend tab up. | 4e | Attach the seismic safety | |
cable to either tab. | |||
|
|
CAUTION: Repeated bending may cause the tab to break off.
Figure 14. Install the Seismic Safety Lines
a.Shut off power to all connected equipment.
b.Temporarily remove a ceiling tile adjacent to the speaker and set it aside.
c.Attach seismic safety cable to one or both line retainer loops at 4c.
d.If a seismic support cable has not been connected at 4c, attach one at 4d.
NOTE: A seismic support cable attached at 4c is recommended. 4d should be 
considered only if attaching to 4c is not possible.
e.Attach seismic safety cable to at least two of the four seismic bendout tabs located on either side of the speaker.
f.Attach the other end of the cables to a sturdy part of the building (studs, roof struts, support girders or similar structure).
g.For additional support lines repeat as needed.
h.Replace the ceiling tile removed in step 4b.
3.Power on the amplifier, test and make any source device and system adjustments following the amplifier operating instructions.
SF 228T Speaker System • Installation 10