Friedrich CP24 Install Cabinet into Window, Attach Support Brackets, Front View Top View, B B A

Install Cabinet into Window Attach Side Curtains to Window Frame

■Handle air conditioner carefully and gently.

■Be sure your air conditioner cabinet does not fall out of the opening during installation or removal.

■The place where the power cord exits the air conditioner should be no more than 4 ft (122 cm) from a grounded 3 prong power outlet.

■Do not place cabinet where front louvers will be blocked.

■Do not place cabinet where outside louvers will be blocked.

1.Center empty cabinet in window. Check that lower rail of air conditioner cabinet is behind and against back side of windowsill. Maintain a firm hold on the air conditioner cabinet. Lower window sash to hold cabinet in place.

2.Measure the distance between the right-hand side of the cabinet and the inside of the window channel.

3.Repeat for the left side. Adjust the cabinet until the distance on each side is the same.

A

B

C

D

A. Window sash

B. Empty cabinet

C. Window channel

D. Window Seal

4.Use a ³⁄₁₆" drill bit to drill 4 starter holes ³⁄₈" deep through the 4 holes in the cabinet and into the windowsill.

5.Attach cabinet to windowsill with 4 - #10 x ¹⁄₂" pan-head Phillips screws.

4.Use a ³⁄₁₆" drill bit to drill 4 starter holes ³⁄₈" deep through the 4 holes in the cabinet and into the windowsill.

5.Attach cabinet to windowsill with 4 - #10 x ¹⁄₂" pan-head Phillips screws.

1.Pull left-hand curtain out until it fits into window channel. Use a ³⁄₃₂" drill bit to drill a starter hole through the hole in the curtain housing and into the lower window sash.

Front View

Top View

B

A

C

A.Left-hand curtain

B.Window channel

C.#10 x ³⁄₄" round-head screw

2.Insert one of the #10 x ³⁄₄" round-head screws through the threaded hole in the top of the curtain.

A

A

B

B

A

A. #10 x ³⁄₄" round-head screw

3.Repeat for right-hand curtain.

Attach Support Brackets

A

B

A. #10 x " pan-head Phillips screws

B.Windowsill

6.Check that air conditioner cabinet is tilted to the outside so that water will run to the outside.

A. Align holes in cabinet with holes in support bracket.

B. #10 x 7/8" 1

8