MDA 4V HD-SDI and SDI User's Guide
RearFront
IR
1
2
3
4 INPUTS
5
6
7
8
1
2
3
4OUTPUTS
5
6
7
8
ENTER
PRESET
Furniture mounting
Furniture mount the MDA using the optional MBU VersaTools under desk mounting kit (part
1. | Attach the mounting brackets to the MDA with the |
| provided machine screws (figure 7). |
DIST |
RIB |
UTIO |
NA |
MPLIFI |
ER |
Figure 7 — |
2. If feet were previously installed on the bottom of the MDA, |
remove them. |
AV
VID
AUD
M |
|
AV | SE |
MA | |
I/OTRIX | RIE |
SWITCHER | |
dB |
|
AUDIO |
|
SETUP |
3. | Hold the MDA with the attached brackets against the |
| underside of the table or other furniture. Mark the location |
| of the screw holes of the bracket on the mounting surface. |
4. | Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) |
| deep in the mounting surface at the marked screw |
| locations. |
Figure 6 — Typical back of the rack installations
5. | Insert #8 wood screws into the four pilot holes. Tighten |
| each screw into the mounting surface until just less than |
| 1/4" of the screw protrudes. |
6. | Align the mounting screws with the slots in the brackets |
| and place the MDA against the surface, with the screws |
| through the bracket slots. |
7. | Slide the MDA slightly forward or back, then tighten all |
| four screws to secure the MDA. |
MDA 4V |