Ice-O-Matic CD300 installation manual Adjustments

Page 13
Adjustments

Adjustments

CD300

The gear motor cam must be properly adjusted to properly position the dispensing rotor.

1.Disconnect electrical power to the dispenser.

2.Locate the sink key, unlock sink and remove it from the dispenser.

3.Observe the position of the rotor through the cube chute. The rotor and cam switch must be in the positions shown. If they are not, the position of the cam must be adjusted.

4.Rotate the rotor until it has blocked the opening.

5.Loosen the cam on the shaft and rotate it until the cam switch follower drops into the lowest part of the cam.

6.Tighten the cam onto the shaft.

7.Return the sink to its original position.

Proper position of rotor at rest.

Cube chute

opening.

Microswitch

cam follower.

Correct positions of cam and rotor at rest.

Page 12

Image 13
Contents Denver, Colorado Mile High Equipment 11100 East 45th AvePart Number Print Date 04/02Introduction Table of ContentsCD300 Ice-O-Matic 11100 E. 45th Ave. Denver, CoSpecifications Diagrams Uncrating Ice Machine Installation Drain Connections -Followall applicable codes Utility ConnectionsHow To Use – Coin Vending How To Use - Push ButtonHow To Use - Room Card Initial Start Up and UseSchedule Sanitation / MaintenanceMonthly SanitizingView when sink assembly is removed Component IdentificationRotor as seen from the top Inside view of ice chuteMaintenance Symptom Service DiagnosisCD300 Probable CauseAdjustments Cam Switches Removal and ReplacementCam Switch #2 Cam Switch #1Button Dispensing Model CD300P Wiring DiagramSchematic Diagram Coin Mechanism CD300C Coin Mechanism CD300C CD300C Key Card CD300K Key Card CD300CCD300K Check these things Before Calling For ServiceDispenser Ice Machine