Manitowoc Ice QM30 Installation Instructions, Electrical Service, Voltage, FUSE/CIRCUIT Breaker

Page 11

Section 2	Installation Instructions

Electrical Service

!Warning

All wiring must conform to local, state and national codes.

Voltage Phase	Electrical Rating

230/50/1	0.6kW

115/60/1	0.6kW

VOLTAGE

The maximum allowable voltage variation is ± 10% of the rated voltage on the ice machine model/serial number plate at start-up (when the electrical load is highest).

!Warning

The ice machine must be grounded in accordance with national and local electrical codes.

!Warning

Never use an extension cord. If an outlet is not within reach of the ice machine’s power cord, have a proper amperage outlet wired closer to the ice machine.

FUSE/CIRCUIT BREAKER

A separate fuse/circuit breaker must be provided for each ice machine.

NOTE: A disconnect means must be provided for field wiring.

ELECTRICAL RATING

The electrical rating is used to help select the wire size of the electrical supply. The wire size (or gauge) also depends on location, materials used, length of run, etc., so it must be determined by a qualified electrician.

Part Number 000001772 07/08

2-3

Image 11

Contents QM30 UnderCounter Model Ice Machines Personal Injury Potential Safety NoticesProcedural Notices Read These Before ProceedingInitial START-UP or START-UP After Automatic SHUT-OFF …… Table of ContentsSequence of Operation Water Supply and Drain Line SIZING/CONNECTIONS ……………Part Number 000001772 07/08 Cleaning and Sanitizing Procedure ………………………………Removal from Service/Winterization General ………………………………………………………………………Model/Serial Number Location Model/Serial Number LocationSection Owner Warranty Registration CardGeneral Information General Information SectionThis page Intentionally Left Blank General DimensionsLeveling the Ice Machine Installation InstructionsLocation of Ice Machine Ice Machine Heat of RejectionFUSE/CIRCUIT Breaker Installation InstructionsElectrical Service VoltageTerminal Block Connections Strain Relief InstallationTerminal Block Wire Connection Electrical Cord Strain ReliefWater Supply and Drain Line SIZING/CONNECTIONS Water Service/DrainsWater Supply Drain ConnectionsTypical Water Supply and Drain Line Sizing and Connections Initial START-UP or START-UP After Automatic SHUT-OFF Correct Ice Bridge Thickness Ice Thickness AdjustmentIce Thickness Adjustment Dial OperationRemove the Overflow Tube Interior Cleaning and SanitizingCleaning and Sanitizing Procedure QM30 45 mlRemoving the Water Pump Remove the Water Trough MaintenanceRemove the Water Pump Exterior Cleaning MaintenanceRemoving the Filter Removal from Service/WinterizationProblem Possible Cause To Correct ChecklistBefore Calling for Service