Manitowoc Ice Q300, Q290, Q160 service manual Problem Dispenser Crushes Ice as it Dispenses

Page 11

Section 1

 

Troubleshooting

Problem: Dispenser Crushes Ice as it Dispenses

 

 

 

Problem

Possible Cause

To Correct

 

 

Dispenser crushes ice as it

The ice in the bin is not the

Replace ice with acceptable.

 

 

dispenses.

proper size and type?

 

 

 

 

Is the ice being used a full size

Adjust ice machine to make a

 

 

 

piece of ice, i.e., are cubes full,

good, complete, not hollow piece

 

 

 

not shallow, etc.?

of ice.

 

 

 

 

 

 

Problem: Ice Continues to Dispense or Dispenses by Itself

 

Problem

Possible Cause

To Correct

 

 

Is the agitation timer set

Timer should agitate for two

Adjust or replace timer if

 

 

properly?

seconds every four hours.

necessary. See Section 3

 

 

 

 

“Component Disassembly”.

 

 

Is the ice door opening fully

The ice door should open a

Adjust door to minimum or larger

 

 

when the dispenser operates?

minimum of 1.5 in. (3.8 cm).

opening.

 

 

 

 

 

 

 

Does ice continue to dispense

Does the gearmotor continue to

Microswitch may be sticking.

 

after the cup has been pulled

run during this time?

Check and clean the microswitch

 

 

away?

 

and linkage to the microswitch.

 

 

 

 

Replace microswitch if necessary.

 

 

Does the ice dispense by itself

Does the dispenser do this at

Check the agitation timer. Adjust

 

 

without anyone around the

regular intervals?

the timer to two seconds on time

 

 

dispenser?

 

and four hours off time. Also

 

 

 

 

check to see if timer has a short.

 

1-7

Image 11
Contents Service Manual Safety Notices Table of Contents This page Intentionally Left Blank Section Troubleshooting Warranty Information Troubleshooting SectionEquipment Overview Room Key Card Activation Runs Problem Possible Cause To CorrectThere is power to Dispenser, however nothingDispenser runs but does not Gearmotor runs, butDispensing paddle wheel does Not turnProblem Ice Continues to Dispense or Dispenses by Itself Problem Dispenser Crushes Ice as it DispensesThis page Intentionally Left Blank Disassembling the Dispenser Parts Component DisassemblyRemoving the Drain Pan Component Disassembly SectionRemoving the Drain Pan Disassembling Rocking Chute/Door Disassembling the Rocking Chute/Door Remove the paddle wheel guard retainer Correct Installation Re-Installing the Paddle Wheel GuardCorrect Installation Incorrect InstallationDisassembling the Dispenser Parts Disassembling the Dispenser Parts For Bin Cleaning Removal of the Gearmotor Remove the bin insulator plate Gearmotor Shaft Seal ReplacementShaft seal marks Underside of bin Insulator plate Gearmotor Shaft Seal Replacement Correct WirinJ ElectricalWith TeVt PinV ElectricalSection Re-WirinJ ProcedureNon-AdjuVtDble Timer NON-ADJUSTABLE TimerTo reVet the DJitDtion timer UVe the followinJ procedure To check the DJitDtion timer, uVe the followinJ procedureAdjusting the Coin Mechanism Timer Before SeriDl NumberV QPA-310 QPA-160 QFA-291 115/60/1 PHSeriDl NumberV 990400000 to After SeriDl NumberV QPA-310 QPA-160 QFA-291 230/60/1 230/50/1 Brown White Ground  Brown 230/60/1 PH 230/50/1 PH QRA-340 QRA-164 Card OperatedSV3060A QRA-330 QRA-163 Card Operated SV3061A Before SeriDl Number QCA-330 QCA-163 Coin OperatedAfter SeriDl Number SV3063 After Serial Number Page Manitowoc ICE, INC