Installation Options, Advance Planning

Installation Preparation

Professional Gas Cooktops

Installation Options

These cooktops can be installed in standard 24" or deeper 25" cabinets.

•In 24" deep cabinets, the front of the cooktop will project approximately 1-7/8" beyond the front of the countertop.

•In 25" deep cabinets, the cooktop will be flush with the front of the countertop.

26-5/8"

21-1/4"

High

Back

•The stainless surface of the cooktop will be 1/2" higher than adjacent countertop.

•Cooktop fits flush to rear of cutout, no additional support is required.

Cooktop

1/2" Above Adjacent

Countertops.

Countertop Level

12"

Low Back

Front Projects Outward as Shown From Standard Depth Cabinets.

8-7/16" 1/2"

3" to Center Line
of Gas Inlet	22-3/4"
	22-3/4"

1/2"

23-1/4"

2-1/2"

Cabinet Face - Projecting Control Panel

Cabinet Face - Flush Control Panel

Cooktop	1/2" Above Adjacent
	Countertops.

Flush With Cabinet Front

Front Flush With Cabinets - a Minimum

of 25-3/4" Cabinet Depth Required

Advance Planning

Refer to “Dimensions and Clearances” for appropriate placement and necessary clear- ances when planning the installation.

•Cabinetry can not be installed directly above the cooktop.

•We recommend the installation of a vent hood above the cooktop surface.

–The vent hood should be at least 24" deep. –The vent hood should be the same width as

the cooktop.

–For 48" models, we recommend the vent hood blower be 1200 CFM.

–For 36" models, we recommend the vent hood blower be 600 CFM.

•Refer to hood installation instructions for height dimensions.

•Working areas adjacent to the cooktop should have 18" minimum clearance between countertop and cabinet bottom.

•Clearance between cooktop and side wall or combustible material must be at least 12" on each side.

•These cooktops require 8" free space below the countertop.

•If the cooktop is installed in an island: –Allow 12" min. clearance at the back to

combustible materials.

–Allow 36" min. above the cooking surface to combustible materials.

•Installation must conform with local codes. In the absence of local codes, the gas cooktop must comply with the National Fuel Gas Code, ANSI Z223.1-1990.

A.G.A. approved.