Tools Materials Required, Gas Supply | GE Monogram ZGU48L4D instruction

Installation Preparation

Tools &

•Saw

•Measuring tape

•Carpenter’s square

•Pipe and fittings as required.

•Manual gas line shut-off valve.

•Gas pressure regulator (supplied)

•Large flat-blade screwdriver

•Pipe wrench

•Gas-resistant pipe joint sealant

•5 foot, 5/8" AGA-certified flexible metal gas supply line. (Length must comply with local codes.)

–If required by local codes, use solid pipe fittings.

Note: Purchase new flexible line. DO NOT USE OLD, PREVIOUSLY USED FLEXIBLE LINE.

	Gas Supply:	7" for 36" Models
	• The natural gas models are designed to	17" for 48" Models
	operate at 6" to 14" water column pressure.	2"
	• The liquid propane models are designed to	Gas Line
	operate at 11" to 14" water column pressure.	Gas Line
	operate at 11" to 14" water column pressure.	to Cooktop
	A regulator is required at the L.P. source to	to Cooktop
	A regulator is required at the L.P. source to
	provide a maximum of 14" water pressure to
	the range regulator.

•These gas cooktops are supplied with 1/2" NPT female gas connection located at the left rear corner.

• A minimum 5/8" dia. metal flexible line is	16"
required.
–Use 5-foot long 5/8" flexible metal tubing.
(Length must comply with local codes.)
• For rigid connection, locate the pipe stub	Locate Gas Supply 2" Maximum
• For rigid connection, locate the pipe stub	Locate Gas Supply 2" Maximum
within area shown.	Protrusion From Wall or on Floor 2" From Wall

•Install a manual shut-off valve in the gas line, in an easily accessible location.

	Electric Supply:	• Locate the electric supply within the area
	These cooktops must be supplied with 120	shown or within reach of the cooktop’s six
	volt, 60 Hz., and connected to a individual,	foot power cord.
	properly grounded branch circuit protected	• To avoid tangling cord with items stored in
	by a 15 amp circuit breaker or time delay fuse.	• To avoid tangling cord with items stored in
	by a 15 amp circuit breaker or time delay fuse.	the cabinet, locate the receptacle on rear
		the cabinet, locate the receptacle on rear
	The power cord of this appliance is equipped	wall, inside the cabinet.
	with a three-prong (grounding) plug which	Receptacle Box Cover Plate
	mates with a standard three-prong grounding	Receptacle Box Cover Plate
	wall receptacle to minimize the possibility of
	shock hazard from this appliance.	Three Prong Plug
	If the electrical service provided does not
	meet the above specifications, it is recom-
	mended that a licensed electrician install an
	approved outlet.
	DO NOT UNDER ANY CIRCUMSTANCES,
	CUT OR REMOVE THE THIRD (GROUND)
	PRONG FROM THE POWER CORD.
	DO NOT USE AN EXTENSION CORD WITH	Three Prong Receptacle
	THIS APPLIANCE.