Finalize Installation

Installation

Professional Gas Cooktops

Step7

Assemble

Burners,

Check

Ignition

(continued)

Adjustable low setting

The open top burners and grill valves have an adjustable low setting. Each valve is individu- ally tested and adjusted before it is shipped. Minor adjustments may be required due to fluctuations in local gas pressure. Adjustments to increase or decrease gas flow may be necessary.

•Turn knob counter-clockwise to the LITE position.

•Once lit, turn the know back to the “LOW” position.

•Remove the knob.

•Insert a thin-blade flat screwdriver into the valve shaft. (3/32" blade width recommended.)

•Grip the shaft with pliers and turn counter- clockwise to lower the flame, or clockwise to increase the flame.

CAUTION: Do not turn the flame so low that it goes out, causing the igniter to spark.

•When the desired setting is made, replace the knob and turn burner off.

Place the burner grates into operating position. Press corner of the grate to the cooktop. The grates should be seated and should not rock.

The grill and griddle are secured with screws at the front. They are designed to be stationary and should not to be removed.

The griddle has two leveling screws beneath the rear flue cover which can be used to adjust to the desired slope. The center screw is for shipping purposes only and should be removed.