American Standard 2580 Spray Installation, TEE and Hose Connection, Lift ROD Guide Installation

3 SPRAY INSTALLATION

Assemble SPRAY BODY (1) to BIDET. Apply putty to underside of SPRAY BODY FLANGE (2) to seal and secure with NUT (3).

Thread SPRAY HOSE (4) with SEAL WASHER (5) to SPRAY BODY (1). Connect other end of HOSE (4) with SEAL WASHER (6) to bottom outlet NIPPLE (7) of the TRANSFER VALVE (8).

Thread SPRAY CAP (9) onto SPRAY BODY (1).

5 TEE AND HOSE CONNECTION

Insert SEAL (1) into ADAPTER (2) and tighten

ADAPTER (2) to side inlet of TRANSFER VALVE (3).

Install SEAL (4) into coupling nut of TEE (5)		Cold
and tighten connection to ADAPTER (2)
Connect HOSE COUPLING NUTS (6)
to Hot and Cold valve bodies		6
and securely tighten.
		3
Hot	5

8

2

9

4

2

1

PUTTY

1

7

6 3 5

4

6
	Front
4 LIFT ROD GUIDE INSTALLATION
Unscrew LIFT ROD NUT (1)
from LIFT ROD GUIDE (2).
Make sure SEAL (3) is seated	2
into ESCUTCHEON of LIFT ROD

GUIDE (2). 3

Drop LIFT ROD GUIDE (2) into rear hole of bidet and from below secure with LIFT ROD NUT (1).

1

6 INSTALL HANDLES

LEVER HANDLES:

Push ADAPTER (1) on VALVE STEM (2), so that the hole of the ADAPTER (1) without spline is facing up. See figure "A".

Thread HANDLE BASE (3) onto DECK ADAPTER (7)

Push HANDLE (4) onto ADAPTER (1).

Find correct position of HANDLE (4) by adjusting male teeth on ADAPTER (1) to female teeth in HANDLE (4).

Secure HANDLE (4) with HANDLE SCREW (5).

Push INDEX CAP (6) in hole of HANDLE (4).

DIVERTER KNOB:

Install HANDLE ADAPTER (8) onto valve stem (12).

Push DIVERTER KNOB (7) onto HANDLE ADAPTER (8).

Install RING (9) onto DIVERTER KNOB 7) and tighten with SCREW (10).

Press on KNOB CAP (11).

TOP

Figure "A"

6

5

4

3

11

10

9

7

1

SPLINE END DOWN 2

7

8

12

M968292