Installation
Instructions
C O L L E C T I O N™ | 2580 |
T H E |
|
by
BIDET FITTING
Thank you for selecting
To ensure that your installation proceeds
U.S. Patent No. 5,819,789
M 9 6 8 2 9 2
Required Tools
Flat Blade Screwdriver
| Tubing Cutter |
Phillips Screwdriver |
|
| Adjustable Wrench |
*Wrench |
|
*Supplied with Fitting | Channel Locks |
1 MOUNTING BIDET FAUCET | |
CAUTION | Turn off hot and cold water |
supplies before beginning. |
Place MOUNTING NUTS (1) onto the VALVE BODIES
(2)and insert VALVE BODIES (2) through outside
holes, from underside of the BIDET LEDGE. Drop the RUBBER RING (3) over the VALVE BODIES (2) and thread DECK ADAPTER (4) onto VALVE BODIE (2) until it locks against the internal stop.
Tighten the MOUNTING NUT (1) to secure the VALVE BODY (2).
Remove ESCUTCHEON (5), WASHER (10) and UPPER GASKET (7) from TRANSFER VALVE (8) and insert into the center forward hole of BIDET.
Roughing-in Dimensions
TRANSFER VALVE |
| ||
| (FOR FLUSHING | FINISHED | |
| RIM OR SPRAY) | WALL | |
BIDET OUTLINE |
|
| |
IS SYMBOLIC | 7/8 DIA. |
| |
DOUCHE ADJ. |
| ||
SPRAY | TO | DIA. |
|
|
| ||
DIA. |
|
| |
|
| ||
|
|
|
| 8 TO 12 |
(C) | (H) |
| |
| DIA. |
| |
DIA. |
FOR GROUND JOINT CONNECTION OR 1/2 " O.D. SLIP (INLETS)
FINISHED | REAR VIEW WITH | |
WALL REMOVED | ||
FLOOR | ||
|
Replace UPPER GASKET (7), and ESCUTCHEON (5) until it locks against the internal stop. Position the side threaded outlet rearward and secure MOUNTING NUT (9).
2 DRAIN INSTALLATION
STOPPER
5
4
3
BIDET
LEDGE
10
2
Assemble
Thread LOCKNUT (6), WASHER (7) and GASKET (8) onto DRAIN BODY (5).
| Apply a bead of PUTTY to underside | 8 |
| ||
| of FLANGE (9). | 7 |
|
|
Feed DRAIN BODY (5) up through BIDET and thread FLANGE (9) fully onto
BODY (5).6
9
PUTTY
BIDET
CLIP
4 2
3
HOT COLD
18
7
9
Tighten LOCKNUT (6) firmly, keeping the PIVOT ROD (3) pointed towards the back of the BIDET.
Push DRAIN ESCUTCHEON (10) onto TAILPIECE (11).
1
5
11
10