Installation
Instructions
C O L L E C T I O N™ | 2581 |
T H E |
|
by
BIDET FITTING
Thank you for selecting
To ensure that your installation proceeds
Certified to comply with ASME A112.18.1M U.S. Patent No. 5,819,789
M 9 6 8 2 9 3
Required Tools
Flat Blade Screwdriver
| Tubing Cutter |
Phillips Screwdriver |
|
| Adjustable Wrench |
*Wrench |
|
*Supplied with Fitting | Channel Locks |
1 MOUNTING BIDET FAUCET | |
| Turn off hot and cold water |
FINISHED | |||
|
| WALL | |
TRANSFER VALVE (FOR FLUSHING | |||
| RIM OR SPRAY) | ||
BIDET OUTLINE |
| ||
IS SYMBOLIC | 7/8 DIA. | ||
DOUCHE SPRAY | ADJ. | ||
TO | DIA. | ||
| |||
| |||
DIA. |
| ||
|
| ||
|
| ||
|
|
CAUTION supplies before beginning. |
Place MOUNTING NUTS (1) onto the VALVE BODIES
(2)and insert VALVE BODIES (2) through outside
holes, from underside of the BIDET LEDGE. Drop the RUBBER RING (3) over the VALVE BODIES (2) and thread DECK ADAPTER (4) onto VALVE BODIE (2) until it locks against the internal stop.
Tighten the MOUNTING NUT (1) to secure the VALVE BODIES (2).
Remove MOUNTING NUT (9), FRICTION RING (10) and UPPER GASKET (7) from TRANSFER VALVE (8) and insert TRANSFER VALVE (8) into the center forward hole of BIDET.
(C)
FINISHED
FLOOR
8 TO 12
DIVERTER AND
VACUUM BREAKER
(H)ASSEMBLY
FOR GROUND JOINT CONNECTION OR 1/2 " O.D. SLIP (INLETS)
REAR VIEW WITH
WALL REMOVED
Replace UPPER GASKET (7) and FRICTION RING (10). Position the side threaded outlet rearward and secure MOUNTING NUT (9). Thread ESCUTCHEON (5) onto TRANSFER VALVE (8) until it seats against the
2 DRAIN INSTALLATION
STOPPER
BIDET LEDGE.
5
9
Assemble
9
10 4 3
BIDET
LEDGE
2
HOT COLD
17
8
ball.
Thread LOCKNUT (6), WASHER (7) and GASKET (8) onto DRAIN BODY (5).
Apply a bead of PUTTY to underside | 8 |
| |
of FLANGE (9). | 7 |
|
Feed DRAIN BODY (5) up through BIDET and thread FLANGE (9) fully onto
BODY (5).6 Tighten LOCKNUT (6) firmly, keeping the PIVOT ROD (3) pointed towards the back
of the BIDET.
Push DRAIN ESCUTCHEON (10) onto TAILPIECE (11).
PUTTY
BIDET
CLIP
4 2
3
1
5
11
10