7 WATER SUPPLY CONNECTIONS
NOTE: FLEXIBLE SUPPLIES ARE NOT INCLUDED AND HAVE TO BE PURCHASED SEPARATELY
Connect water supplies to FAUCET (1) with 1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D.
Do not over tighten. Be careful not to kink copper supply when bending. Use tubing cutter to cut to proper length.
1
2 | COUPLING NUT |
8 FINISH DRAIN INSTALLATION
Position BIDET fixture and secure to floor.
Insert lift rod into lift rod guide.
Position EXTENSION ROD (1) onto
Remove one end of CLIP (4) from PIVOT ROD (7) by squeezing ends together while sliding.
Insert PIVOT ROD (7) into second or third hole in EXTENSION ROD (1) and reassemble CLIP (4). (EXTENSION ROD (1) may need to be bent.)
Adjust STOPPER height by repositioning EXTENSION ROD (1) and tightening THUMBSCREW (3).
Using metal TAILPIECE (5), make connection to the TRAP (6).
2
1
3
Cold
FERRULE
3
1
5
6
7
4
9 TEST INSTALLED FITTING | 1 |
With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks.
Operate both handles to flush water lines thoroughly. Turn DIVERTOR (6) to rim wash and bidet spray.
Operate Lift Rod (3) and fill Bidet with water. Check that DRAIN STOPPER (4) makes a good seal and retains water in Bidet. Adjust stopper height by repositioning Lift Rod (3) and tightening Thumbscrew (5).
Release DRAIN STOPPER (4) and check all drain connections for leaks. Tighten if necessary.
2
6
3
5
10 SERVICE
To change direction of handle |
| ||
rotation, proceed |
| 90° | |
as follows: | 2 | ||
| |||
Turn valve to OFF position. |
| ||
| 1 | ||
Remove HANDLE and |
| ||
ADAPTER if present. |
|
| |
Remove SPRING CLIP (1). |
|
| |
Lift STOP WASHER (2), |
|
| |
turn 90° and replace. |
|
| |
Replace SPRING CLIP (1). |
|
| |
Replace HANDLE ASSEMBLY. |
| ||
SPRAY (3) may accumulate dirt |
| ||
causing distorted and reduced |
| ||
water flow. Unscrew and remove | 3 | ||
SPRAY (3) and rinse clean. |
| ||
|
| ||
Replace SPRAY (3) and operate |
| ||
handles several times from |
|
| |
OFF to ON position. Do not |
|
| |
force, handles turn only 90˚. |
|
|
4
11 CARE INSTRUCTIONS:
2
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE
M968292