Hisense Group KFR-3208GW instruction manual Installation of the indoor unit, Appendix Installation

Appendix: Installation

3. Installation of the indoor unit

Remove the wall plate

(1)Remove the fixing screws and keep them for future use (not used during installation).

(2)Press the two triangular signs on the outer shell and remove the fixing clip.

(3)Remove the wall plate.

Mount the wall plate

(1)Determine the correct position of the plate with a level (never use the naked eyes!). The plate should be level.

(2)Fix the plate with §¶6mm expansion bolts for cement walls and with wood screws for wood or plaster walls.

Caution: Adequate space should be reserved for the installation of the indoor unit. To avoid running noise and vibration, the wall plate should be fixed tightly on the wall.

Make the wall hole

Select the position of the hole according to the positions of the indoor and outdoor units. The hole should be slightly lower than the wall plate.

The diameter of the hole is 65mm and the hole should be made with the outside end a little lower.

The site should be cleaned after the hole is made.

Caution: Check carefully before the hole is drilled to make sure that there is no cables or tubes in the area.

Wall plate

Fixing screw

Fixing clip

75	Right tube
	75 hole center
Left tube
hole center

Indoor

Outdoor

Connect the tubes of the indoor unit

A. Connect the electric wires

(1)Open the front panel and remove the cover of the electric box. (2)Remove the wire clip in the electric box.

(3)Put in the wires from the back of the indoor unit and pull them out from the front.

(4)Connect the wires firmly to the terminal panel.

(5)Fix the wires with the clip, replace the cover and close the front panel.

Caution: Make sure that the numbers of the terminals are the same

as those of the terminal panel.

B. Connect the tubes

(1)Do not let dust, dirt, air and water into the tubes during installation, so never remove the tube plugs if installation is not due.

(2)Remove the nuts at the tube joints of the indoor unit, align the center of the tube flare (apply anti-freezing oil on the cone head), tighten the cone-shaped nuts with the hand first, then tighten up with a spanner.

Anti-freezing oil

is applied hereConnecting Flared

tubetube

Caution: Avoid leakage from loose connection or damage of the flare from over-tightening.

Set the outdoor unit

Set the indoor unit

21