Hisense Group KFR-3208GW Remote Control Unitcontinued, TIMER ON button, TIMER OFF button, Auto

Remote Control Unit(continued)

TIMER ON button	:The air conditioner starts at the set time.
TIMER OFF button	:The air conditioner stops at the set time.
TIMER SET/CANCEL button	This button is used to set/cancel the time at which you wish the air conditioner to go on or off.
MODE selector button Use this button to select AUTO, HEATING, DRY or COOLING mode.
(AUTO)	A :When this setting is selected, the air conditioner calculates the difference between the

set thermostat and the room temperature and automatically switches to the "COOLING"

	or "HEATING” mode appropriately.
(HEATING)	:The air conditioner makes the room warm.
(DRY)	:The air conditioner reduces the humidity in the room.
(COOLING)	:The air conditioner makes the room cool.
(FAN)	:The air conditioner makes the room's temperature suitable.
FLAP button	Press this button either to select	to	set the airflow direction to one of the six possible
	positions manually, or to select	the	sweep function, which moves the flap up and down
	automatically.
	:The airflow direction can be set manually.(six positions)
	:The flap moves up and down automatically.

A :Press the FLAP button and set the airflow directions as desired. (refer to Adjust the Airflow Direction).

FAN SPEED selector	A	:The air conditioner automatically decides the fan speeds.
button		: High fan speed.
		:Medium fan speed.
		:Low fan speed.
1 HR TIMER button	1HOUR	:When you press this button, regardless of whether the unit is operating or stopping,
(1-HOUR OFF TIMER)	the unit operates for one hour and then shuts down.
ACL button	Puts the remote control unit into pre-operation status. Always press this button after
	replacing the batteries.

A/C SENSOR button When you press this button (use a small-tipped object such as a ballpoint pen), the mark will appear at the display. And the room temperature is detected by the sensor which is built into the indoor unit and the air conditioner is controlled accordingly.

!	NOTE	If the remote control is located near a heat source, such as a space heater or
		indirect sunlight, press the A/C SENSOR button to switch to the sensor in the
		indoor unit.

Automatic switching between cooling and heating

This unit automatically switches between cooling operation and heating operation according to the difference

between the room temperature and the set temperature.

NOTE

The remote control unit sends the temperature signal to the air conditioner regularly at three minute intervals. If the signal from the remote control unit stops for more than ten minutes due to the loss of the remote control unit or other trouble, the air conditioner will switch to the temperature sensor which is built into the indoor unit and control the room temperature. In these cases, the temperature around the remote control unit may differ from the temperature detected at the air conditioner,s position.

7