Hisense Group KFR-3208GW Adjusting the Fan Speed, Adjusting the Airflow Direction

Adjusting the Fan Speed

A. Automatic

	A	position.
Simply set the FAN SPEED selector to the				A
					mode is selected. When the air
A microprocessor in the air conditioner automatically controls the fan speed when the
co nditioner starts operating, the difference		between the room temperature and the set temperature is detected by
the microprocessor which then automatically switches the fan speed to the most suitable level.
B. Manual	If you want to adjust fan speed manually during operation, just set the FAN SPEED selector
	as desired.[	(High),	(Medium), or	(Low)]

Adjusting the Airflow Direction

1. Horizontal

!CAUTION

The horizontal airflow can be adjusted by moving the vertical vanes with your hands to the left or right.

When the humidity is high, the vertical vanes should be in the front

position during the cooling or dehumidifying operation. If the vertical vanes are positioned all of the way to the right or left, condensation may begin to form around the air vent and drip down.

2. Vertical	The vertical airflow can be adjusted by moving the flap with the remote control unit Do not
	move the flap with your hands.Confirm that	the remote control unit has been turned on.
	Then, use the FLAP button to set	either the sweep function or one of
	the six airflow direction settings.

		6
	COOL	5
FLAP	and
	MODE	4
	DRY
ON	OFF	3
SLEEP SET	CANCEL	2	1
	SWEEP	HEAT
A/C SENSOR	ACL

A.Sweep function

The flap starts moving up and down to

deliver air over the sweep range.

B.Automatic Function

The flap moves up and down automatically from to during the cooling or drying operation, from to during the heating operation. Referring to the above illustration.

!

!

NOTE

CAUTION

The flap automatically closes when the unit is off.

¡ñUse the FLAP button on the remote control to adjust the position of the flap.

If you move the flap by hand, the flap position according to the remote control and the actual flap position may no longer match.If this happens,shut off the unit, wait for the flap to close, and then turn on the unit again; the flap position will now be normal again.

¡ñDo not have the flap pointed down during cooling operation. Condensation may begin to form around the air vent and drip down.

10